steering knuckel ???? - The 1947 - Present Chevrolet & GMC Truck Message Board Network

neal · 03-26-2007, 07:06 PM

Doing a disc brake conversion;Bought gmc paul stock height kit after i get one installed then I measure. The new steering knuckels are 1" greater outside to outside than the one on the drums I pulled off. On the drums from top down to center of axle is 5 7/8" On the new ones its 6 1/4" I also got new coils with a 1" drop, will they work with the a arms spread 1" greater can I even use these steering knuckels?

03-26-2007, 07:06 PM	#1
neal New Member Join Date: Oct 2006 Location: pensacola florida Posts: 14	steering knuckel ???? Doing a disc brake conversion;Bought gmc paul stock height kit after i get one installed then I measure. The new steering knuckels are 1" greater outside to outside than the one on the drums I pulled off. On the drums from top down to center of axle is 5 7/8" On the new ones its 6 1/4" I also got new coils with a 1" drop, will they work with the a arms spread 1" greater can I even use these steering knuckels?

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.