|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
04-03-2007, 07:29 PM
|
#1 |
|
Registered User
 Join Date: Dec 2002
Location: Northern Virginia
Posts: 1,268
|
Floor Pan Install Question
I am replacing most of the floor in the front passenger area. I got a truck floor pan that I am using. The truck floor pan had the rails that were spot welded on.. I cut part of the truck rail off of the floor. I left the flat part spot welded to the floor pan. Question is do I drill out the 20+ spot welds and then have to weld up those holes. Or do I leave the rail on. It does ride about 1/8 higher where it sits, I am sure I could flex it down to weld to outer floor in. with the rail on the floor is noticeably much stronger.
Opinions? |
|
|
|
04-03-2007, 08:18 PM
|
#2 |
|
Senior Member
Join Date: May 2006
Location: Philadelphia, Pa. 19454
Posts: 9,761
|
Re: Floor Pan Install Question
Don't follow, any pics.???? J.
__________________
Semper Fi...Uncle Sam, you da man All parts offered to help are free, unless otherwise noted Dont try this stuff in my build thread, unless you have 55 years of mechanical OTJ training SAFETY FIRST AS usual, off topic They say your mind goes second, can't remember the first Jim |
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
