|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
09-07-2002, 07:43 AM
|
#1 |
|
Truck Nut
Join Date: Mar 2000
Location: Big Lake,MN,US
Posts: 134
|
Is the year of the axle stamped on the ring or pinion?
its hard to order parts when you don't know the year.
__________________
'70 3/4 manual w/350 4.56's .Doing a ground up on a '67 4x4 4"lift. |
|
|
|
09-08-2002, 09:06 PM
|
#2 |
|
Registered User
Join Date: Dec 1999
Location: Austin, TX, USA
Posts: 7,723
|
Some gear sets have a date code on them, and the ID code stamped on the pass side axle tube, on the top, between 4 an 8 inches from the cast section, should identify what year it is.
__________________
44 Willys MB 52 M38A1 64 Corvette Coupe 68 Camaro 'vert LT1 & TH700 69 Z/28 355 12.6's @110 69 Chevy Short Step 4 1/2"/7" drop 72 Jimmy 4WD 4spd 4" & 35's 02 GMC 2500HD 4x4 Duramax |
|
|
|
|
09-08-2002, 09:23 PM
|
#3 |
|
Registered User
Join Date: May 2000
Location: Frankfort, Kentucky, USA
Posts: 2,163
|
Most rings have a machining date on them. Pinions probably do too, but never had one out. The date on the ring is an approxomite date of axle assembly.
__________________
'69 CST Short fleetside Lowered, 400 small block, 700R4, 4 wheel disc brakes, front sway bar & rear camaro sway bar (in progress) '87 V10 4x4 Short Fleetside Quad Suspension and Dual Tanks |
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
