![]() |
![]() |
#1 |
Registered User
Join Date: Jan 2007
Location: Central Coast California
Posts: 1,029
|
ubolt size
Need a verification on ubolt size for H052 axle.
I'm measuring 3.30" diameter. (I've found some of these made by Rancho.) I've some 3.375" (3 3/8" ) in my possession.... can I use these? Or, does the tolerance need to be exact. I've plates that would fit 3 3/8... probably fit the 3.30" also. Also, can someone verify the 4th Ubolt on the passenger side of a D60 needs to be 4". The other 2 I have are 3 1/8" for the driver side. Thanks
__________________
1972 K20 Suburban 5.7/700r4/NP205 Dana 44/H052 Sold ![]() 1972 C10 5.3L/4L60E 12bolt 5Lug - Sold ![]() 1971 K5 Blazer 6.0L LQ9 4L60E NP205 Dana 44/H052!!! ![]() 1970 K3500 1ton CrewCab 8.1L/Allison1000/NP205 Dana 60/14B!!!! - Sold ![]() ![]() ![]() 1988 V30 CCLB 7.4L/TH400/NP205/Dana 60/Dana 70!!! (Sold) ![]() 2003 K2500HD 8.1/Allison1000/NP263 ![]() |
![]() |
![]() |
![]() |
#2 |
Registered User
Join Date: Jan 2008
Location: Alamo
Posts: 104
|
Re: ubolt size
why dont u just get em made 4 you? thats what i did cost a bit more but they're a whole lot stronger than the stuff the lift companies sell.you check out ur local bolt an screw shop
__________________
![]() |
![]() |
![]() |
![]() |
#3 |
Registered User
Join Date: Feb 2000
Location: Modesto, CA
Posts: 1,842
|
Re: ubolt size
That is preety close, you could prolly get away with them working, just make sure you keep um torqued and re-check the toruque after a bit
![]()
__________________
1972 K5 MPFI454/Sm465/Np205/D60/14FFd/Re-Centerd H1s w/Swamper Iroks ![]() Last edited by Burt4x4; 02-27-2008 at 07:16 PM. |
![]() |
![]() |
![]() |
#4 |
Post Whore
![]() Join Date: Feb 2000
Location: Rose Hill, KS, USA
Posts: 12,689
|
Re: ubolt size
I'd definitely use the ones you have, when you torque them down it will tighten them around the axle tube just fine.
__________________
1970 Blazer with a 400 sbc and 4" lift 1980 Pontiac Trans Am, 455 Oldsmobile 2012 Kawasaki Concours 14 |
![]() |
![]() |
![]() |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|