|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
10-26-2002, 03:59 PM
|
#1 |
|
67-72 Addict!
Join Date: Feb 2002
Location: The TAX State!
Posts: 7,856
|
Wiring Diagram question
I just saw a post on the board showing a "Typical 67-72" dash panel schematic. This is the same version I have always seen and is in my 70' service manual. My question is why do they show 2 Dark Green wires going to the Ignition Switch, a dark blue wire going to the fuse panel in "view A on the right side, and a few other differences?. I just pulled another complete dash harness this morning and have yet to see these 2 dark green wires actually going to the ignition switch. Did GM screw this diagram up perhaps?. Can anybody shed some light here?. I don't want to pull my existing harness out just yet if the new one isn't going to work!. Thanks
__________________
Jim 1970 C/10 Fleetside w/Ghost Flames Lowered 4.5" front and 4" rear (Raked) 355/350 Turbo w/shift kit 10" Redneck Performance Verter w/2500 stall Hooker Super Comps part#2808-1 Performer RPM Air-Gap 12 Bolt w/3:73 gears- Eaton Posi Comp Cams XE262 with 1.6 Crane Energizers, Road Demon 625 and Brodix IK 180 heads |
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
