|
10-26-2002, 07:40 PM
|
#1 |
|
Registered User
Join Date: Apr 2000
Location: Chester County PA, USA
Posts: 1,228
|
Tach Problems
My factory tach in my Sub dosent go past 1500 RPM..It does return to zero. Is it fixable? Does anybody else have this problem?
Randy 
__________________
72 k/10 short wideside 72 k/5 Blazer 72 K/5 Blazer - obstacle course racer 72 custom/10 8' bed 70 K/5 Blazer 67 C-30 GMC Flat bed 86 GMC K2500 Plow Truck 85 GMC K3500 84 M1008 85 M1008 77 G30 Motor Home 72 Sears 12hp Tractor Glenmoore, Pennsylvania |
|
|
|
10-26-2002, 11:49 PM
|
#2 |
|
its all about the +6 inches
Join Date: Jan 2001
Location: Hilliard Ohio
Posts: 2,690
|
TTT.
I have seen this before, but we never figured out what it was. |
|
|
|
|
10-27-2002, 01:57 AM
|
#3 |
|
Senior Member
 
Join Date: Dec 1999
Location: Darrington, Washington
Posts: 3,963
|
Pull it out,make sure the needle isnt binding on the face plate,also they get dry in their after sitting a while,make sure dash is grounded(they are grounded when back plate is screwed into dash,or you could use a ground wire alligator clip to clip to back and to dash for outside testing.make sure the needle moves freely,dont force it,but give it some slight assistance with finger,very slight.Ive had them stick,and stay at a certain rpm when shutting off.worst case senario is buy a new center piece(just the tach)im sure someone here would buy your tach to play with in hopes of fixing.
|
|
|
|
|
10-27-2002, 09:32 AM
|
#4 |
|
Registered User
Join Date: Apr 2000
Location: Chester County PA, USA
Posts: 1,228
|
Thanks guys, I'm gonna look at it this morning befor the race starts.
Randy
__________________
72 k/10 short wideside 72 k/5 Blazer 72 K/5 Blazer - obstacle course racer 72 custom/10 8' bed 70 K/5 Blazer 67 C-30 GMC Flat bed 86 GMC K2500 Plow Truck 85 GMC K3500 84 M1008 85 M1008 77 G30 Motor Home 72 Sears 12hp Tractor Glenmoore, Pennsylvania |
|
|
|
 |
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
