|
04-29-2002, 09:01 PM
|
#1 |
|
Registered User
Join Date: Jun 2001
Location: barnum
Posts: 127
|
GTA 350tpi
Just purchased at jefferson swap meet 89 350 tpi complete engine from a gta pontiac.Has anyone installed one of these in 70 chevy truck and is it a good combo with a 700r4.Will trans from chevy fit etc.Looked like a deal at 500.and running.
|
|
|
|
04-29-2002, 10:02 PM
|
#2 |
|
its all about the +6 inches
Join Date: Jan 2001
Location: Hilliard Ohio
Posts: 2,690
|
The eng and tranny are both Chevy...by the third gen F-body ('82 - '92 Camaro/firebird) they all got Chevy motors when it came to the small block. If you get eh wire harness and puter, it won't be too hard. You'll need to revamp the fuel system too.
In the 3rd gen F-bodys, the engines were; 2.5 4 cylinder...Pontiac 2.8 V-6....Chevy 3.1 (or was it a 3.4?) V-6...Chevy 3.8 V-6....Buick 3.8 TURBO V-6 (only in t/a one year) also buic then the 305 and 350 which were both chevy motors. ------------------ '69 G.M.C. 350/350. Trying to clean up the left over damage from the Dope-Smokin-Old-Man I've been dubbed the Longhorn Freak/Fanatic/Expert, I just hope I can live up to it. FINALLY got the HORNIAC...a '70 one ton Longhorn with a Pontiac 350/350 and lots of 'personality'. Check out The Longhorn Webite. If you need a pic posted, E-mail me at longhornmail@yahoo.com Andy, in Columbus Ohio |
|
|
|
|
04-29-2002, 10:19 PM
|
#3 |
|
Account Suspended
Join Date: May 2000
Location: IL
Posts: 0
|
i have tpi harness and puter if you need by some odd chance
------------------ Randy- Lincoln, IL randy@ccaonline.com 2177353230 -71 C-10 350/CH465/3.07, assemble it, yeah right, that'll happen in this world,(not) -84 Z28 Camaro 5.0L 700R4, 3.73, beater, paid way too much for it like an idiot,, -84 Firebird SE 2.8L T-5, rod knocking, dammit,, -82 Firebird 350 4bolt (TBL)/TH350, not running, dammit... buy/sell/hoard/trade most any GM vehicle parts of any kind -parting out: '81 Cutlass Supreme Brougham *Paint is overrated © RSS Enterprises 2000 |
|
|
|
|
05-06-2002, 08:05 PM
|
#4 |
|
Senior Member
Join Date: Jun 2001
Location: Gaston, SC
Posts: 580
|
My dad has that same motor (and 700r4) in his 84 blazer. It was a deisel truck before the swap. I hope you got the computer and all with it. His came from a totaled 89 gta with 50k miles. It cost $480. I wish I could find a deal like that!
------------------ milanplechata@hotmail.com Lexington, SC 1968 c/10 lwb 250/3 on the tree 1970 CST/10 lwb no motor/trans http://communities.msn.com/6772GMTru...68longbed.msnw Every man dies, but not every man truly lives..
__________________
Milan 1964 Chevelle SS 283/M20 |
|
|
|
 |
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
