|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
07-09-2008, 03:13 PM
|
#1 |
|
Registered User
 
Join Date: Feb 2008
Location: Williamsburg, Va
Posts: 226
|
Body mount bolt torque
Hey guys, does anyone know if there is a factory torque for the radiator support and body bolts and, what are they? I am closed to installing my cab back on the frame and check alignment again but figure if there is a torque value that would help me out a lot. Thanks in advance.
|
|
|
|
07-09-2008, 09:09 PM
|
#2 |
|
Senior Member
Join Date: Jul 2001
Location: Muskegon,MI,USA
Posts: 6,026
|
Re: Body mount bolt torque
Per the Shop Manual, the torque values are: Radiator supports 20 lb/ft
Front cab mounts 50 lb/ft Rear cab mounts 20 lb/ft Jim
__________________
1971 Shortbox step side 4x4, 350 sbc, 3:07 rear end 1965 Impala SS 400 sbc, Muncie rock crusher 1966 Impala SS 396 bbc, TH 400 1969 El Camino, 350 sbc, TH 350 1971 Snowplow built on a Blazer frame 1972 GMC Short bed, stepside, TH 400, 427 BBC |
|
|
|
|
07-10-2008, 01:58 PM
|
#3 |
|
Registered User
Join Date: Feb 2008
Location: Williamsburg, Va
Posts: 226
|
Re: Body mount bolt torque
Thank you, thoses readings are much lower than I anticipated and I have tighten them to much in the past. This info helps me a lot, Thank you.
|
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
