|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
09-15-2008, 06:49 PM
|
#1 |
|
Registered User
 
Join Date: Aug 2008
Location: Austin, Texas
Posts: 78
|
balljoint nuts torque on 1970 c10?
How much do you torque the upper balljoint nuts? These are the nuts/bolts that replace where the original rivets were in the a-arm, not the single one at the spindle. I have a manual, but dont see the spec anywhere... Elsewhere I might just take it 50-65 ft lbs, but it'd be nice to know for sure...
Thanks a lot, Tim |
|
|
|
09-15-2008, 08:49 PM
|
#2 |
|
Senior Member
Join Date: Apr 2008
Location: Franklinton NC
Posts: 1,309
|
Re: balljoint nuts torque on 1970 c10?
I think its around 20-25ft lbs
|
|
|
|
|
09-15-2008, 08:57 PM
|
#3 |
|
Registered User
Join Date: Jan 2007
Location: Topeka,KS
Posts: 778
|
Re: balljoint nuts torque on 1970 c10?
I'd say light pink with a 3/8" ratchet and a wrench. Light pink being the color your face turns when torqueing. Light pink, pink, medium red, red, and purple.
|
|
|
|
|
09-15-2008, 09:16 PM
|
#4 |
|
Registered User
Join Date: Aug 2008
Location: Austin, Texas
Posts: 78
|
Re: balljoint nuts torque on 1970 c10?
Ha! I would've been the redder shades if this board wasnt here. Maybe sheared one of the bolts at 50 ft/lbs. Thanks much.
|
|
|
|
|
09-15-2008, 10:11 PM
|
#5 |
|
its all about the +6 inches
Join Date: Jan 2001
Location: Hilliard Ohio
Posts: 2,690
|
Re: balljoint nuts torque on 1970 c10?
they are only 1/4 or 5/16 inch bolts... they can't take too much.
|
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
