![]() |
Register or Log In To remove these advertisements. |
|
|
![]() |
|
Thread Tools | Display Modes |
![]() |
#1 |
Registered User
Join Date: Jan 2009
Location: Jacksonville FL
Posts: 47
|
spring hanger bolt hole alignment
This project is getting humorous. After all the fight to get frame rivets out, and the original hangers off, I now find that the 2 1/2" Mc Gaughy rear leaf spring hangers don't line up with the holes in the frame.
They are off about 1/8th of an inch on the bottom holes and about a quarter of an inch on the top ( wide side ). Is this the norm to have to drill ( offset ) your own holes to fit the new hanger? Thanks again for helping, the people on this site are awesome! |
![]() |
![]() |
![]() |
#2 |
Senior Member
Join Date: May 2004
Location: Caldwell,Tx.
Posts: 3,648
|
Re: spring hanger bolt hole alignment
I installed a set years ago from Belltech . I think I had to place a C Clamp over the top side of the hanger and compress it a little to get everything lined up . Then put the bolts in and tighten everything .
Frank
__________________
Born and proudly residing in a Red State ! |
![]() |
![]() |
![]() |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|