|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
06-02-2009, 09:19 PM
|
#1 |
|
Registered User
Join Date: Dec 2000
Location: Ringtown,PA
Posts: 555
|
what is my pinion angle????
found some very confusing and contradictory articles on the net, need help??? im using an angle finder and when i put it on the pinion yoke across where the cap mounts i get 10 degrees and on the bottom of the shaft i get 5 degrees. the pointer is on the same side of zero for both, what do i have??? Thanks, Devin
__________________
68 chevy 406 small block, budget drag racer, new best e.t 11.91 @112 67 nova numbers matching 327 4 speed 13.6 @ 102mph 70 longhorn c-30 402/4 speed 70 c-10 swb 402, muncie 4 speed 94 s-10 350/th350 3:73 posi 71 c-20 402/th400 towrig for racetruck. 72 4wd lifted on 35's 72 350/3 speed winter beater |
|
|
|
06-02-2009, 10:23 PM
|
#2 |
|
motor exploder
Join Date: Mar 2009
Location: Pittsburgh, PA
Posts: 2,346
|
Re: what is my pinion angle????
I've always done it by taking the angle from the yoke coming off the tranny, and adding it to the angle of the rearend yoke. So, if you had -2 coming off the tranny yoke and -2 off the rearend yoke, the total pinion angle is -4 degrees. I've never done it using the driveshaft method, so I may be totally wrong. I've always set my trucks up (the ones I've lowered) for somewhere between -2/-4 degrees.
__________________
Adam 1969 Chevy CST/10 stepside, DART Big M/TREMEC Magnum Extreme/3.73's w/Detroit Truetrac 1965 Chevy Bel Air Wagon (daily driver), 327/TH350,10 bolt w/3.08's 1961 Chevy Bel Air Sport Coupe, ZZ454/M21/9" rear w/3.50's & Detroit Truetrac 2005 GMC 1500 ccsb 2wd, 6.0L/4L65e/3.73 G80 2006 GMC 2500HD ccsb 4x4, DMax LBZ/Allison 6spd/4.56's w/Detroit TrueTrac   Use the SEARCH function on this forum - it is your friend!! |
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
