2006 2500HD Ext Cab Driver's Door Weather Strip Replacement

[larry horne]

I need to replace the weather stripping that goes around the entire cab opening on the driver's side doors. Its a 2006 2500HD Ext Cab. I'm talking about the molded rubber strip that meets at the center of the door seal and runs around the perimeter of the door opening. I've glanced at the interior trim and don's see a lot of screws like in the old days. I have to remove the plastic trim at the door bottom and the side trim runnig from the floor up the side column of the rear seat (this is where the rear seat belts attach).

I think I can sneak the molding around the rest of the trim and the head liner so any information on removal of the door seal and the rear trim would be appreciated.

Lar

[Josh]

The trim it held in with metal clips, just pull up on em and they will pop off. The only thing you will have to unbolt is the seat belt if you can't sneak it past that panel by popping it loose. It's a fairly quick and simple job.

Josh

[larry horne]

Originally Posted by Josh

The trim it held in with metal clips, just pull up on em and they will pop off. The only thing you will have to unbolt is the seat belt if you can't sneak it past that panel by popping it loose. It's a fairly quick and simple job.

Josh

Thanks Josh. Do yo have any experience with removing the bezel around the AC cluster. The temp control lights are out.

Lar