|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
06-29-2009, 10:21 PM
|
#1 |
|
Registered User
Join Date: Sep 2007
Location: san diego,ca
Posts: 125
|
what should voltage be WHILE CRANKING?
So if the battery shows 12v when truck is off, what should it be while cranking?
|
|
|
|
06-29-2009, 11:27 PM
|
#2 |
|
its all about the +6 inches
Join Date: Jan 2001
Location: Hilliard Ohio
Posts: 2,693
|
Re: what should voltage be WHILE CRANKING?
I don't like seeing it drop below ten, but the reality of it is... it can go low, as long as it starts, and it has enough amps to roll over at a decent pace.
|
|
|
|
|
06-29-2009, 11:53 PM
|
#3 |
|
Senior Member
Join Date: Jan 2005
Location: SUNNY WARM BIKE RIDING COTTONWOOD ARIZONA
Posts: 2,097
|
Re: what should voltage be WHILE CRANKING?
10.5 is usually the limit and i personally wouldnt want it going much lower.
|
|
|
|
|
06-30-2009, 05:44 AM
|
#4 |
|
ENGINE BUILDER
Join Date: Apr 2006
Location: Shortsville n.y.
Posts: 344
|
Re: what should voltage be WHILE CRANKING?
Crank it for 15 seconds and voltage should not go below 9.6.
__________________
JIM ZAG |
|
|
|
|
06-30-2009, 06:47 AM
|
#5 |
|
Old member
Join Date: Jan 2002
Location: Liberty, & Garden City S.C. , U.S.
Posts: 19,945
|
Re: what should voltage be WHILE CRANKING?
If you have a TPI unit they say it needs to stay above 11 volts to crank. I know you have to cut the factory coil wire out and replace it with straight wire. The factory has a resistants built into it to drop the voltage.
__________________
1971 LWB Custom, 6.0LS & 4L80E, Speedhut.com GPS speedometer & gauges with A/C. 20" Boss 338's Grey wheels 4 wheel disc brakes. My Driver Seeing the USA in a 71  Upstate SC GM Truck Club 2013,14 and 2016 Hot Rod Pour Tour http://upstategmtrucks.com/ Get out and drive the truck this summer and have some fun! It sucks not being able to hear! LWB trucks rule, if you don't think so measure your SWB! After talking to tech support at Air Lift I have found out that the kit I need is 60811. Per the measurements I gave them. Ride height of truck inside spring and inside diameter of springs. |
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
