automatic linkage bushing - The 1947 - Present Chevrolet & GMC Truck Message Board Network

jcfoote60 · 08-05-2009, 08:35 PM

My automatic linkage HAD a bushing that fits in the lower part where the rod goes from the column down to the rest of the linkage. Mine was so bad it crumbled and fell apart. It's plastic, and does anyone know where I can get one? I checked the LMC catalog and zippo. I could try a couple junk yards but a new one would be the ticket. Let me know if you know of a source for one. Thanks

Jim

**Jurassic-1** · 08-05-2009, 11:03 PM

The bushings are usually metal and fit snugly intu a rubber grommet. I have used grommets from the small parts bins at Ace or Tru value hardware stores and then cut a sleeve from some small tubing slide the rod throgh and place a flat washer followed by a cotter pin.

LUCKTRUCK · 08-05-2009, 11:22 PM

try www.classicparts.com, part number 91-064 may be what you're looking for, not sure though ??

LUCKTRUCK

mclairmo · 08-05-2009, 11:55 PM

NAPA might carry it in the Dorman line of goodies.

08-05-2009, 08:35 PM	#1
jcfoote60 Active Member Join Date: Jun 2005 Location: Idaho Posts: 263	automatic linkage bushing My automatic linkage HAD a bushing that fits in the lower part where the rod goes from the column down to the rest of the linkage. Mine was so bad it crumbled and fell apart. It's plastic, and does anyone know where I can get one? I checked the LMC catalog and zippo. I could try a couple junk yards but a new one would be the ticket. Let me know if you know of a source for one. Thanks Jim

08-05-2009, 11:03 PM	#2
Jurassic-1 Registered User Join Date: Jul 2007 Location: New River Arizona Posts: 1,180	Re: automatic linkage bushing The bushings are usually metal and fit snugly intu a rubber grommet. I have used grommets from the small parts bins at Ace or Tru value hardware stores and then cut a sleeve from some small tubing slide the rod throgh and place a flat washer followed by a cotter pin.

08-05-2009, 11:22 PM	#3
LUCKTRUCK Registered User Join Date: May 2007 Location: new jersey Posts: 610	Re: automatic linkage bushing try www.classicparts.com, part number 91-064 may be what you're looking for, not sure though ?? LUCKTRUCK

08-05-2009, 11:55 PM	#4
mclairmo Registered User Join Date: Jan 2006 Location: Take Off Posts: 1,908	Re: automatic linkage bushing NAPA might carry it in the Dorman line of goodies.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.