The 1947 - Present Chevrolet & GMC Truck Message Board Network







Register or Log In To remove these advertisements.

Go Back   The 1947 - Present Chevrolet & GMC Truck Message Board Network > 47 - Current classic GM Trucks > The 1967 - 1972 Chevrolet & GMC Pickups Message Board

Web 67-72chevytrucks.com


Reply
 
Thread Tools Display Modes
Old 08-05-2009, 09:17 PM   #1
Sammy
Registered User
 
Join Date: Apr 2000
Location: Bonne Terre, Mo
Posts: 3,005
Signs of a bad P/S gear box

I had previously done a frame off on the GMC. Since then I had always noticed that turning the steering wheel to the left it was just slightly harder than to the right. And as time went on it got to the point that the feel got stiffer as time went on. Not knowing if I was fighting air or a bad pump. I just lived with it. Recently I changed to a serp setup and susquently changed the P/S pump it self. And noticed just a slight improvement but still not quite right. Then after about a week I was driving pulling into a driveway (10 MPH). The gearbox locked up to the left completely. Matter of fact only movement to the left was less than 1/4 turn to the left. Luckly I wasn't doing 50 or something. I have since removed the gearbox and installing a replacement. I had never heard of this type of complete failure. Usually just a cracked case or leak. Just thought I'd pass this info along in case anyone was having similar symptoms with their power steering. This could have caused a serious accident especially since it just went from difficult turning (above normal) in one direction to a complete failure in a short period of time. Grand total of miles driven from assy to complete failure was less than 1,000 miles.
__________________
'69 Chevy Long Fleet & '71 GMC Short Step & Project "ODD BALL"


"You can wash a pig, soak it in most expensive perfume. In the end it is still just a pig."

ODD BALL build thread http://67-72chevytrucks.com/vboard/s...d.php?t=478629"
Sammy is offline   Reply With Quote
Old 08-05-2009, 10:27 PM   #2
BCOWANWHEELS
Registered User
 
Join Date: Nov 2006
Location: KINGSPORT,TN.
Posts: 3,035
Re: Signs of a bad P/S gear box

time for a new steering box....
__________________
I BELIEVE IN JOHN 3:16
BCOWANWHEELS is offline   Reply With Quote
Old 08-05-2009, 11:59 PM   #3
mclairmo
Registered User
 
Join Date: Jan 2006
Location: Take Off
Posts: 1,908
Re: Signs of a bad P/S gear box

never seen that before, thanks for the tip
mclairmo is offline   Reply With Quote
Old 08-06-2009, 09:43 AM   #4
UltraBlue71
Registered User
 
UltraBlue71's Avatar
 
Join Date: Feb 2009
Location: OKC OK
Posts: 489
Re: Signs of a bad P/S gear box

yikes! like you said at least you werent hauling a-- down the the highway when it decided to quit...
__________________
"You can put lipstick on a pig, sure it's pretty pig, but it's still just a PIG...

71 LWB
UltraBlue71 is offline   Reply With Quote
Old 08-06-2009, 10:04 PM   #5
Sammy
Registered User
 
Join Date: Apr 2000
Location: Bonne Terre, Mo
Posts: 3,005
Re: Signs of a bad P/S gear box

Replaced the gear box today. Since the box was dry, it was very difficult to purge the system of air. I have replaced the pump and bled them which can be a pain but bleeding the entire system was much more time consuming. Bright side is that it now steers to left. The old box after removal didn't rattle and still didn't go past straight ahead. I assume something was lodged in the worm gear. (Ball bearing possibly)
__________________
'69 Chevy Long Fleet & '71 GMC Short Step & Project "ODD BALL"


"You can wash a pig, soak it in most expensive perfume. In the end it is still just a pig."

ODD BALL build thread http://67-72chevytrucks.com/vboard/s...d.php?t=478629"
Sammy is offline   Reply With Quote
Old 08-06-2009, 10:16 PM   #6
BCOWANWHEELS
Registered User
 
Join Date: Nov 2006
Location: KINGSPORT,TN.
Posts: 3,035
Re: Signs of a bad P/S gear box

I ALWAYS JACK UP THE COMPLETE FRONT end and start the engine and turn steering wheel 5-6 times lock to lock to remove air. works for me.
__________________
I BELIEVE IN JOHN 3:16
BCOWANWHEELS is offline   Reply With Quote
Old 08-06-2009, 10:28 PM   #7
Beefcake
Registered User
 
Join Date: Mar 2003
Location: Motor City
Posts: 540
Re: Signs of a bad P/S gear box

i just had mine rebuilt for $150.
__________________
72 GMC Camper Special 2500.

currently has 350/350/14 bolt. 383 and 400 tranny is in the works.
Beefcake is offline   Reply With Quote
Old 08-06-2009, 10:50 PM   #8
Sammy
Registered User
 
Join Date: Apr 2000
Location: Bonne Terre, Mo
Posts: 3,005
Re: Signs of a bad P/S gear box

I had my jacked up also. For about an hr I went from stop to stop. Even bled the lines at the gear box. It wasn't till I took it for a ahort drive that it hinted of being power steering again.
And a rebuilt box was about the same price $140.
__________________
'69 Chevy Long Fleet & '71 GMC Short Step & Project "ODD BALL"


"You can wash a pig, soak it in most expensive perfume. In the end it is still just a pig."

ODD BALL build thread http://67-72chevytrucks.com/vboard/s...d.php?t=478629"
Sammy is offline   Reply With Quote
Old 08-06-2009, 11:50 PM   #9
El Jay
Gone to greener pastures
 
Join Date: May 2007
Location: Gateway to the Delta
Posts: 7,354
Re: Signs of a bad P/S gear box

Thanks for the heads up on your problem.
That's 1 of them things ya just want to store in the back of your ol' noggin.
__________________
'69 Chevy 1/2 T LWB Stepper: Daily Beater
'72 GMC 3/4 T Fleet: Another Daily Beater
'72 Plymouth Gran Coupe: ?


"Ah women. They make the highs higher and the lows more frequent." Friedrich Nietzsche

"Never kick a fresh turd on a hot day." Harry S. Truman

GUN CONTROL: Never having to say, "I missed you."

Always fire two warning shots into your attacker's chest area before putting a bullet between his eyes. Paraphrased from Louis Awerbuck
El Jay is offline   Reply With Quote
Old 08-10-2009, 02:23 PM   #10
Sammy
Registered User
 
Join Date: Apr 2000
Location: Bonne Terre, Mo
Posts: 3,005
Re: Signs of a bad P/S gear box

Update and or food for thought. After the replacement of the gear box and having difficulty belleding the system I noticed how un like P/S the response was. Found out if you remove the pressure line on the pump and remove the fitting. Behind the fitting are several key componets. A spring and valve assy. This valve on mine was lodged sideways and stuck inside. With a little jiggle removed the valve and spring. On the tail side of the valve is a small screen. It was stopped up with a small piece of thread tape or something. Blew it out with air, reinstalled it works better than new if it's possible..So if your P/S get sluggish this would be an easy thing to remove clean the screen out. The screen is really small. You will have to look closely to see it's even there. Smaller than the diameter of a pencil eraser. Imagine after several years it would gather some debri, and not much to clog that screen anyway.
__________________
'69 Chevy Long Fleet & '71 GMC Short Step & Project "ODD BALL"


"You can wash a pig, soak it in most expensive perfume. In the end it is still just a pig."

ODD BALL build thread http://67-72chevytrucks.com/vboard/s...d.php?t=478629"
Sammy is offline   Reply With Quote
Reply

Bookmarks

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 01:26 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com