|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
12-21-2009, 04:22 PM
|
#1 |
|
The Beach Cruiser
Join Date: May 2009
Location: Panama City, Florida
Posts: 358
|
Front end alignment after new parts
I am planning on replacing the following on my 66 panel
• Upper and Lower Ball Joints • Outer and Inner Tie Rod Ends • Adjusting Sleeves • Idler Arm Pitman arm My question is how do I line everthing up close enough to drive it to the alignment shop? Are there any diagrams around? I would take it to a shop and have them do it all but I want to paint all the parts berfore the install. Thanks for any help.
__________________
1999 Silverado DD  1966 Panel Truck 2003 Harley Road Glide  1967 Schwinn Tandem Single Speed |
|
|
|
12-21-2009, 04:55 PM
|
#2 |
|
It'd be alot cooler if you did
Join Date: May 2003
Location: Three Rivers, MI
Posts: 2,345
|
Re: Front end alignment after new parts
I just make the tie rods the same length as the old ones and make sure you go driectly to the alignment shop.
|
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
