![]() |
Register or Log In To remove these advertisements. |
|
|
![]() |
|
Thread Tools | Display Modes |
![]() |
#1 |
Registered User
Join Date: Apr 2007
Location: New Brunswick, Canada
Posts: 201
|
![]()
Can somebody check out this link and tell me if this would fit my 67 C20?
I see the brackets on the axle but don't think it is a trailing arm set up like my C20. http://moncton.kijiji.ca/c-cars-vehi...AdIdZ178399214
__________________
If your not living for something, your dieing for nothing... |
![]() |
![]() |
![]() |
#2 |
Watch out for your cornhole !
![]() Join Date: Jun 2003
Location: Azle, Texas
Posts: 14,162
|
Re: 3/4 Ton Rear End Help Please
That's not a coil spring rearend. It's out of a later leaf spring truck.
__________________
I'm on the Instagram- @Gearhead_Kevin |
![]() |
![]() |
![]() |
#3 |
TOTY 2006
![]() Join Date: Dec 1999
Location: Magalia CA USA
Posts: 2,270
|
Re: 3/4 Ton Rear End Help Please
Not a bolt in, but if you have any fab skills, $30-40 for new perch mounts depending whom you order from, access to a welder and understand how to degree a rear end, you can make this work. dont forget that you may need to either get a new driveshaft or using a different rear ujoint to make this work as well.
|
![]() |
![]() |
![]() |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|