|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
03-16-2010, 06:50 PM
|
#1 |
|
Registered User
Join Date: Feb 2006
Location: henderson ky
Posts: 196
|
Need Help : Accelerator cable install
I just bought a 72 with a bocthed up throttle cable. I bought a new cable but can't figure out how to get the cable through the pedal arm. can anyone help? i did a search and could find the answer.
|
|
|
|
03-16-2010, 07:35 PM
|
#2 |
|
Senior Member
Join Date: Jul 2001
Location: Muskegon,MI,USA
Posts: 6,026
|
Re: Need Help : Accelerator cable install
There is a plastic sleeve on the cable that keeps it from going through the hole in the pedal arm. Pull the cable out and push the sleeve out of the hole. There is a slot in the plastic sleeve that will allow you to remove the sleeve. Once the sleeve is off of the cable the end of the cable can be pulled through the hole in the pedal arm.
Jim
__________________
1971 Shortbox step side 4x4, 350 sbc, 3:07 rear end 1965 Impala SS 400 sbc, Muncie rock crusher 1966 Impala SS 396 bbc, TH 400 1969 El Camino, 350 sbc, TH 350 1971 Snowplow built on a Blazer frame 1972 GMC Short bed, stepside, TH 400, 427 BBC |
|
|
|
|
03-16-2010, 11:55 PM
|
#3 |
|
Registered User
Join Date: Feb 2006
Location: henderson ky
Posts: 196
|
Re: Need Help : Accelerator cable install
thanks jim, my new one has a much larger sleeve, with no slot. do i just use the old sleeve?
|
|
|
|
|
03-17-2010, 05:08 AM
|
#4 |
|
Senior Member
Join Date: Jul 2001
Location: Muskegon,MI,USA
Posts: 6,026
|
Re: Need Help : Accelerator cable install
Yes, just use the old sleeve. The new one must be made for a slotted pedal arm.
Jim
__________________
1971 Shortbox step side 4x4, 350 sbc, 3:07 rear end 1965 Impala SS 400 sbc, Muncie rock crusher 1966 Impala SS 396 bbc, TH 400 1969 El Camino, 350 sbc, TH 350 1971 Snowplow built on a Blazer frame 1972 GMC Short bed, stepside, TH 400, 427 BBC |
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
