|
04-09-2010, 08:03 AM
|
#1 |
|
Registered User
Join Date: Mar 2009
Location: Tahlequah, OK
Posts: 31
|
Driveshaft Yoke
On my TH400 the yoke is bolted into the back of the trans. I assume this is because the donor vehicle had a two piece driveshaft. What I plan on doing is running a one piece shaft, just as personal preference.
The question: Can I run without that bolt in the yoke? I'm just a driveshaft away from from a test drive! 
__________________
'66 C20 converted to C10, 454/TH400 '66 C10 saved from crusher 
|
|
|
|
04-09-2010, 08:58 AM
|
#2 |
|
Registered User
Join Date: Mar 2009
Location: Tahlequah, OK
Posts: 31
|
Re: Driveshaft Yoke
Nevermind. I found some info I needed.
__________________
'66 C20 converted to C10, 454/TH400 '66 C10 saved from crusher
|
|
|
|
 |
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
