![]() |
Register or Log In To remove these advertisements. |
|
|
![]() |
|
Thread Tools | Display Modes |
![]() |
#1 |
Registered User
Join Date: Jan 2009
Location: Carmichael, CA
Posts: 77
|
65 Upper ball joint riveted in
So I've ground off the rivet heads on the upper side of the ball joint, but still cant seem to get it off... using a screw driver and a BFH to try and drive and pry it off.. but no luck.
anyone have any tips? is it cheaper/easier to just get a new upper control arm set up for the new bolt in ball joints? Last edited by Choptop32; 05-09-2010 at 06:54 PM. |
![]() |
![]() |
![]() |
#2 |
Registered User
Join Date: Dec 2009
Location: Phoenix, AZ
Posts: 25
|
Re: 65 Upper ball joint riveted in
I ground the head's off, then you can pry them out. Then grind down the remaining rivet, and finally use a air chisel to push them the rest of the way. Sounds like a lot but it's pretty simple.
|
![]() |
![]() |
![]() |
#3 |
...just another truck junkie..
![]() Join Date: May 2009
Location: Watertown, SD
Posts: 698
|
Re: 65 Upper ball joint riveted in
Drill into the rivet. You don't even need to drill it out completely, just drill into it from the top. Next, get a good punch and a heavy hammer and pop those rivets out. The hole you drill into the rivet will help by allowing the rivet to collapse it in. They will still be stubborn, but you can get them out. Just keep at it and they will eventually come out.
__________________
Mike "Bear" Shea |
![]() |
![]() |
![]() |
#4 | |
Registered User
Join Date: Jan 2007
Location: Denton, Texas
Posts: 356
|
Re: 65 Upper ball joint riveted in
Quote:
![]()
__________________
Andrew '69 C-20(292, 4-speed) Retired Daily Driver '64 C-10(250, 3-speed) Fixerupper '97 F*rd Mustang GT(4.6L, 5-speed) Daily Driver If I only wanted two pedals I'd have bought a bicycle.
![]() |
|
![]() |
![]() |
![]() |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|