which direction for the crossmember? - The 1947 - Present Chevrolet & GMC Truck Message Board Network

beau396 · 02-19-2003, 06:58 PM

Putting a bbc in a '67 swb fleetside that was a small block a/t truck. I need to know which direction the crossmember faces. I am using one out of a '71 with Th400. One side of the crossmember has one hole drilled right in the center and the other side has a bunch ( four I think for the e-brake cable mounts)? also when it is on the garage floor (level) one end is higher then the other where the tranny mount goes. If I get it the wrong way it would screw up the driveline phasing. If somebody could look at their trucks crossmember or knows off hand I would appreciate it.

Thanks

crazy longhorn · 02-19-2003, 07:42 PM

The center part , where the trans mount bolts needs to slope down hill to the rear when its mounted in the truck....crazyL

beau396 · 02-19-2003, 07:55 PM

Thanks crazyL that makes the most sense.

02-19-2003, 06:58 PM	#1
beau396 Registered User Join Date: Nov 2002 Location: oak harbor wa Posts: 61	which direction for the crossmember? Putting a bbc in a '67 swb fleetside that was a small block a/t truck. I need to know which direction the crossmember faces. I am using one out of a '71 with Th400. One side of the crossmember has one hole drilled right in the center and the other side has a bunch ( four I think for the e-brake cable mounts)? also when it is on the garage floor (level) one end is higher then the other where the tranny mount goes. If I get it the wrong way it would screw up the driveline phasing. If somebody could look at their trucks crossmember or knows off hand I would appreciate it. Thanks

02-19-2003, 07:42 PM	#2
crazy longhorn Fabricate till you "puke" Join Date: Jun 2002 Location: Ill Posts: 9,402	The center part , where the trans mount bolts needs to slope down hill to the rear when its mounted in the truck....crazyL __________________ 69 longhorn,4" chop,3/5 drop, 1/2 ton suspension/disc brakes,1 1/2" body drop,steel tilt clip, 5.3/Edelbrock rpm intake/600 carb, Hooker streetrod shorties,2 1/2" exhaust/ H pipe/50's Flows , 6 spd Richmond trans,12 bolt/ 3.40 gears....

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

02-19-2003, 07:55 PM	#3
beau396 Registered User Join Date: Nov 2002 Location: oak harbor wa Posts: 61	Thanks crazyL that makes the most sense.



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.