|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
10-24-2010, 09:46 PM
|
#1 |
|
Registered User
Join Date: Aug 2008
Location: Pittsburg, KS
Posts: 2,466
|
GMC Pauls cab bushing kit questions
I ordered the GMC Pauls cab/rad./bed mount kit. Did you have to drill out the washers to fit the front cab mount bolts? Did you use the top washers that were supplied with the kit? I thought they seemed to big. Shouldn't the washer fit down into the recess in the floor? Does anyone have any installed photos of this kit?
Heres the photo from GMC pauls http://www.gmcpauls.com/pictures/69-...supportkit.jpg Thanks in advance,
__________________
Doug Looking for a 67-72 short bed driver..... Last edited by m6z; 10-24-2010 at 09:48 PM. |
|
|
|
10-25-2010, 05:46 AM
|
#2 |
|
Senior Member
Join Date: Jul 2001
Location: Muskegon,MI,USA
Posts: 6,026
|
Re: GMC Pauls cab bushing kit questions
The bolt fits into the recess without a washer on it. (A lot of the bolts were welded at the factory but is not necessary).
Here is a picture of the front mount as installed. There are extra washers, (used as shims) in this picture since the cab was shimmed to match the bed. I am not sure if these mounts came from GMC Pauls but they are pretty typical. Jim
__________________
1971 Shortbox step side 4x4, 350 sbc, 3:07 rear end 1965 Impala SS 400 sbc, Muncie rock crusher 1966 Impala SS 396 bbc, TH 400 1969 El Camino, 350 sbc, TH 350 1971 Snowplow built on a Blazer frame 1972 GMC Short bed, stepside, TH 400, 427 BBC |
|
|
|
|
10-25-2010, 08:35 AM
|
#3 | |
|
Registered User
Join Date: Aug 2008
Location: Pittsburg, KS
Posts: 2,466
|
Re: GMC Pauls cab bushing kit questions
Quote:
__________________
Doug Looking for a 67-72 short bed driver..... Last edited by m6z; 10-25-2010 at 08:35 AM. |
|
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
