auto cross member help

[67cst]

hey guys i have a question for ya...well 2 or 3 maybe :p i used an 85 auto cross memeber for the th400 on the shortened 71 frame, what my question is will my hump in the 67 cab clear the tranny? my dad bolted up the lokar shifter to the tranny and he thinks the tranny might rub against the bottom of the hump...we are going to put the cab on this weekend to see forsure but could someone tell me if it will or not, and if it doesnt hit how much space minimum should there be in between the tranny and floor, and also if they hit we thought about putting i high hump in the floor instead of the stock low hump, which leads to another question....do any humps un bolt or are they all part of the floor? thanks a lot for any help guys

Derek

[67cst]

ttt...come on guys lets hear some input

[Longhorn Man]

Can't say if it'll rub your floor since you have a non-stock cross member. But small lock trucks with the TH400 had the low hump floor stock. (onless a 4X4)
As for the high hump conversion...the high hump part is a bolt in....but you'll have to cut out the low hump.

[Project1970]

With a stock-style crossmember (I think...I had the 3spd to THM400 conversion done by Rick's Pickup Parts, but I did the THM400 to 700R4 swap myself) the THM400 on a small block fits just fine under the low hump...heck, so does the 700R4.

[67cst]

thanks for the pic longhornmail and info guys....i know the th400 will fit but im concerned because the 85 tanny x memeber seems to make the tranny higher at the tail end..i guess ill have to wait tillthis weekend to letcha know whats up..thanks again guys