![]() |
Register or Log In To remove these advertisements. |
|
|
![]() |
|
Thread Tools | Display Modes |
![]() |
#1 |
Registered User
Join Date: Sep 2010
Location: NY
Posts: 48
|
After market Crossmember for Single Shaft Conversion?
My truck was converted to a single piece driveshaft and the crossmember was cut at the bottom to clear the lower angle (about 3").
Is there an after market crossmember for this? How many hours should it take to replace the crossmember? |
![]() |
![]() |
![]() |
#2 |
Registered User
Join Date: Sep 2003
Location: Boise ID
Posts: 609
|
Re: After market Crossmember for Single Shaft Conversion?
I hope this works (the link) http://www.earlyclassic.com/catalog.aspx and another one http://www.classicperform.com/Store/...ck/6372LDL.htm On the early classic enterprise link go to catalog drop down to crossmembers.
__________________
"72" Red CORVETTE 4-speed 350 "70" Chevy Short Bed early stages of resto. Edel 600 cfm carb Weiand Stealth Intake HEI shorty Headers 4/2 Drop 295 50R 15 TOYO on 10 inch wide corvette rally rims at all 4 corners. "CHEVY RULES" ![]() Last edited by 70short; 03-07-2011 at 01:35 PM. |
![]() |
![]() |
![]() |
#3 |
Registered User
Join Date: Sep 2010
Location: NY
Posts: 48
|
Re: After market Crossmember for Single Shaft Conversion?
thanks so much!
|
![]() |
![]() |
![]() |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|