Tilt columns - The 1947 - Present Chevrolet & GMC Truck Message Board Network

cjohnson6772 · 06-06-2011, 08:40 PM

How hard is it to rebuild an original truck column?

What are the pieces that you would say should ALWAYS be replaced?

What should I look for in a good used column (typical problem areas)?

ETsC10 · 06-06-2011, 10:23 PM

I can't answer your Q's but there is a great write-up with exploded views here.

Eddie H. · 06-07-2011, 01:41 PM

It's not that difficult. Just disassemble, clean and inspect all the parts and replace anything that shows excessive wear. (Usually, upper and lower bearings and turn signal switch)

06-06-2011, 08:40 PM	#1
cjohnson6772 Registered User Join Date: Dec 2010 Location: NC Posts: 666	Tilt columns How hard is it to rebuild an original truck column? What are the pieces that you would say should ALWAYS be replaced? What should I look for in a good used column (typical problem areas)?

06-06-2011, 10:23 PM	#2
ETsC10 Hand Crafted C-10 Join Date: Aug 2006 Location: Burien, WA Posts: 5,180	Re: Tilt columns I can't answer your Q's but there is a great write-up with exploded views here.

06-07-2011, 01:41 PM	#3
Eddie H. Registered User Join Date: Mar 2001 Location: Paradise TX USA Posts: 1,200	Re: Tilt columns It's not that difficult. Just disassemble, clean and inspect all the parts and replace anything that shows excessive wear. (Usually, upper and lower bearings and turn signal switch) __________________ "Negative people always seem to have a problem for every solution"

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.