AZ Cab for patches

[t korinek]

Selling pieces of this cab $25 each + shipping, solid cab supports, clean firewall, good radio section
Let me know if you need something, its going to scrap in a few days
Thanks,
Tom

[projectjimmie68]

How are the rear corners about a foot square each side?

[projectjimmie68]

Still waiting on price for patches..................

[t korinek]

Project jimmie Cab corners? $65 shipped for both

[BuildinA68]

are any of the 4 wheel drive parts for sale? looking for drive shafts for a short bed 4speed - np 205 combo

[brian mac]

How much for the raised pad area around where the door jamb switches would have been installed? Driver and passenger side please.

[projectjimmie68]

That is the price for the floor sections. Correct? That is the parts I need.The cloor corner sections,each side about a foot square. Thanks

[tanman722001]

Hi what you want for the section circled?And are the sill plates and good I see the chrome has some rust on them?My zip is 27028.Thanks Tony

[t korinek]

Heres some more pics
tanman $25 shipped for that piece, sill plates were shot
projectjimmie, heres pics of the floor areas can you outline what piece you need?
brian mac pics of the areas I think your talking about, outline what you need if possible $60 shipped for both pieces.
buildina68 I should have a front drive shaft out of a 72 blazer with a 4 speed & 205 for $70 shipped, no rear driveshaft though, is that hank3 in your avatar?

[t korinek]

More pics

[t korinek]

& some more pics

[gottattooz]

How much for the radio section, shipped to 33542?? Thanks.

-Josh

[tanman722001]

I need a coupleday to get the money up.And will need your address as I will be sending you a money order.Thanks Tony

[projectjimmie68]

All I want is the floor corners. 12" in from rocker and 12" in from back wall. That corner on each sde. Price plus shipping. Thanks

[brian mac]

How do I outline on your pics? You have the right area pictured.

[projectjimmie68]

Not sure how to send you a picture of that area. All I need is the floor corner that is usally rusted out on each side.

[t korinek]

Brian mac is this area outlined enough?
Project jimmie The outlined area 1' square? $70 shipped for those pieces, there will be a the heavy rear floor bracket attached. I'd cut from the seam on the back wall in 1'& from the inner edge of the rocker 1'

[t korinek]

forgot to attach the pics

[t korinek]

gottatooz $35 shipped for the radio section
tanman ok

[projectjimmie68]

I think I will pass. Thanks

[brian mac]

Need a little more metal on the top cut and not so much on the bottom cut. Maybe 2" on all sides of the raised pad area. Does that make any sense?Will you do less than 60 bucks on that area ?

[t korinek]

Brian mac How about the pieces like this, do you need /want the whole pillar or just the outside of it? I'd be cutting right under the uppper hinge plate I could do $50 shipped for both sides

[brian mac]

That will work. Just need the outside piece, not the entire pillar.Pm me your info for money order.

[gottattooz]

Originally Posted by t korinek

gottatooz $35 shipped for the radio section
tanman ok

I'll take it. Send me payment method and info. I have paypal.

-Josh

[t korinek]

gottattooz hows this outlined area look for your cut? basically the whole center section from dash pad to the bottom of the dash