|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
11-30-2011, 07:11 PM
|
#1 |
|
Registered User
Join Date: Apr 2011
Location: greenville sc
Posts: 558
|
Cleaned IAC today, but did I harm the IAC?
I took the IAC off and cleaned it today it wasn't dirty at all really. Anyway while I had it out I pushed on the tip of the plunger and it went in some but didn't pop back out. By doing that did I hurt the iac in anyway?
|
|
|
|
12-01-2011, 02:50 AM
|
#2 |
|
Registered User
 
Join Date: Apr 2009
Location: New Freedom Pa.
Posts: 1,335
|
Re: Cleaned IAC today, but did I harm the IAC?
No, normally it will not hurt it. The IAC is just a motor, it has a little plunger that is controlled by the ECM. Basically a controlled vacuum leak with the engine running.
after re installing cycle the key and leave it on, it will go through its motions and reset itself. Desert |
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
