|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
12-12-2011, 10:16 PM
|
#1 |
|
Registered User
Join Date: Sep 2011
Location: Nampa, Idaho
Posts: 8
|
Blazer rust repair questions
I'm getting ready to tackle the rust in the cab of the Blazer and am wondering in what order to do the following patches - front floor supports, floors, kick panel, inner & outer rockers, and a-pillar. Also, with the top on and the torsion boxes (rocker boxes) being good do I need to brace the cab? The body is on the frame. Thanks in advance.
|
|
|
|
12-13-2011, 08:56 AM
|
#2 |
|
Senior Member
 
Join Date: May 2006
Location: Philadelphia, Pa. 19454
Posts: 9,505
|
Re: Blazer rust repair questions
Just about the way you have it listed in your question....goin to be hard to weld, since the torsion box is in it, youll only be able to weld the top side and cant rust proof the bottom.
Just about everyone braces
__________________
Semper Fi...Uncle Sam, you da man All parts offered to help are free, unless otherwise noted Dont try this stuff in my build thread, unless you have 55 years of mechanical OTJ training SAFETY FIRST AS usual, off topic They say your mind goes second, can't remember the first Jim |
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
