|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
02-27-2012, 02:58 AM
|
#1 |
|
Registered User
Join Date: Aug 2009
Location: PA
Posts: 883
|
dumb pinion shim question
sorry for the stupid question, but im putting diy4x's e-z blocks (the ones that bolt to the spring pack) for the front. do i put the pinion angle shims between the ez inch and the sping? or between the perch and the ez inch? basically all i want to know is should i put the shim above or below the ez inch? thanks.
|
|
|
|
02-27-2012, 10:40 AM
|
#2 |
|
Registered User
Join Date: Apr 2000
Location: Chester County PA, USA
Posts: 1,228
|
Re: dumb pinion shim question
I would put it between the ez inch and the spring perch.
This way the center bolt will tighten up strait.
__________________
72 k/10 short wideside 72 k/5 Blazer 72 K/5 Blazer - obstacle course racer 72 custom/10 8' bed 70 K/5 Blazer 67 C-30 GMC Flat bed 86 GMC K2500 Plow Truck 85 GMC K3500 84 M1008 85 M1008 77 G30 Motor Home 72 Sears 12hp Tractor Glenmoore, Pennsylvania |
|
|
|
|
02-27-2012, 11:21 AM
|
#3 |
|
Registered User
Join Date: Feb 2000
Location: Modesto, CA
Posts: 1,842
|
Re: dumb pinion shim question
Yes on the perch BUTTT if they are aluminum throw them away and get STEEL ones. Especialy for the front. Alum will crack, wiggle out = loose spingpacks up front = scary ride/crash.
I had this happen, lucky for me it was the rear, turned my spingperches into rounded off bent arches but I didn't crash. .025c  
__________________
1972 K5 MPFI454/Sm465/Np205/D60/14FFd/Re-Centerd H1s w/Swamper Iroks 
|
|
|
|
|
02-27-2012, 06:51 PM
|
#4 |
|
Registered User
Join Date: Aug 2009
Location: PA
Posts: 883
|
Re: dumb pinion shim question
There solid steel dont worry haha im not that stupid lol
Posted via Mobile Device |
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
