Can someone here do me a favor? I need a measurement - The 1947 - Present Chevrolet & GMC Truck Message Board Network

creativecustoms · 02-28-2012, 05:35 PM

Anyone that has done a 7" or close drop in the rear, can you please measure from the top of the frame to the top of the axle housing? Mine is a 68 so anything close to that.

Thanks

6772owner · 02-28-2012, 07:32 PM

I can get a measurement from my 72' when I get home, it has the ECE rear bag kit, so Im not sure the actual amount of drop at the pressure I usually run... but I will get you a ride height and the measurement you requested if it will help...

SCOTI · 02-28-2012, 09:59 PM

It would be about 1" or less between the axle & bottom of the frame (no c-notch) so add the height of the frame to that.

creativecustoms · 03-01-2012, 03:02 PM

Cool. Thank you
Posted via Mobile Device

02-28-2012, 05:35 PM	#1
creativecustoms Registered User Join Date: Jan 2012 Location: Rapid City, SD Posts: 4	Can someone here do me a favor? I need a measurement Anyone that has done a 7" or close drop in the rear, can you please measure from the top of the frame to the top of the axle housing? Mine is a 68 so anything close to that. Thanks

02-28-2012, 07:32 PM	#2
6772owner Gearhead Join Date: Jan 2008 Location: Colorado Posts: 1,193	Re: Can someone here do me a favor? I need a measurement I can get a measurement from my 72' when I get home, it has the ECE rear bag kit, so Im not sure the actual amount of drop at the pressure I usually run... but I will get you a ride height and the measurement you requested if it will help... __________________ 2002 Saturn SL2, My D/D 2019 Ford Fusion SE, Ecoboost - Wife's D/D 1993 Camaro Z28, A4, CAI, Cat-Back Exhaust Project C10 (my 72' C10 w/96' LT1, 700R4, bagged F&R, 18's (for now), Short/Fleet) -- SOLD! Build Thread: http://67-72chevytrucks.com/vboard/s...d.php?t=313644

02-28-2012, 09:59 PM	#3
SCOTI Registered User Join Date: Apr 2001 Location: DALLAS,TX Posts: 22,064	Re: Can someone here do me a favor? I need a measurement It would be about 1" or less between the axle & bottom of the frame (no c-notch) so add the height of the frame to that. __________________ 67SWB-B.B.RetroRod 64SWB-Recycle 89CCDually-Driver/Tow Truck 99CCSWB Driver All Fleetsides @rattlecankustoms in IG Building a small, high rpm engine with the perfect bore, stroke and rod ratio is very impressive. It's like a highly skilled Morrocan sword fighter with a Damascus Steel Scimitar..... *Cubic inches is like Indiana Jones with a cheap pistol.*

03-01-2012, 03:02 PM	#4
creativecustoms Registered User Join Date: Jan 2012 Location: Rapid City, SD Posts: 4	Re: Can someone here do me a favor? I need a measurement Cool. Thank you Posted via Mobile Device

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.