|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
04-17-2012, 05:01 PM
|
#1 |
|
Simple? What's simple?
 
Join Date: Apr 2007
Location: Southeast CT
Posts: 1,472
|
Has anyone used LT1 corvette exhaust manifolds?
Looking to see if anyone has used these before. They're true 2.5" center dumps and dimensionally similar to my ram's horns - I scored this set on ebay for cheap.
They belong on C4 corvette LT1 and LT4, 92 - 96 as far as I can tell. They have a single port for EGR / AIR on the top of the center runner, which is either an M18 or M22 plug (already have both sizes lined up to order once I measure  ) Either way, when I get into this project you'll get pictures of how well they fit and what I decide to do with 'em. Should be a nice match to my Vortecs
__________________
CURRENT '50 GMC 100 shortbed Gen IV 4.8 LS - 4L65E (Secret truck, Shhh!!!) Build '63 Buick Wildcat Coupe 401ci Nailhead (Very much in pieces) Photos '66 Impala SS convertible 327-QJet-glide (4 speed swap one of these days...) Photos '69 CST/10 4x4 SWB Stepper 350 2bbl - NV4500/NP241C (Broken Truck!) '72 Sierra Grande 2WD LWB fleetside 350-TH350 Refresh '99 K2500 Silverado RCLB 5.7 Vortec - NV4500/NP241C (Daily) '99 K2500 Suburban 7.4 Vortec - NV4500/NP246 (still working out the bugs) SOLD '71 Custom/10 2WD LWB fleetside - '72 GMC K/3500 Dually (Sold to redryder) Last edited by JJorgensen52; 04-17-2012 at 05:06 PM. |
|
|
|
04-17-2012, 10:00 PM
|
#2 |
|
Senior Member
Join Date: Feb 2011
Location: Corona, CA
Posts: 1,836
|
Re: Has anyone used LT1 corvette exhaust manifolds?
I had a set of these; one side bolted up fine and the other; (pass side) was bumping into the engine stand. I think these are the same side, just not sure which one. Also got these off Ebay cheap and they had the AIR holes welded up.
__________________
MusicMan70 1961 GMC Suburban |
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
