|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
04-30-2012, 06:06 PM
|
#1 |
|
Registered User
Join Date: Sep 2011
Location: Conway, SC
Posts: 26
|
NP205 and automatic trans question
Hello, I have a 72 1/2 ton 4x4 with a th350 trans and a np205 transfer case. I want to change the trans to a th400. Do I only need the 400 adapter to connect to the 205? Is the 400 longer than the 350. Any other issues. Thanks
|
|
|
|
04-30-2012, 07:33 PM
|
#2 |
|
Registered User
Join Date: Aug 2009
Location: S.C.
Posts: 1,593
|
Re: NP205 and automatic trans question
Not 100%, I believe the 400 is longer and the spline count is different. (27vs32?)
__________________
'86 C-30 dually, 454/tbh400 '73 K-20 350/350/205 (sold  )I'm kinda like duct tape- no real purpose, but handy to have around. |
|
|
|
|
04-30-2012, 08:25 PM
|
#3 | |
|
I built it
Join Date: Sep 2008
Location: Bakersfield ca
Posts: 744
|
Re: NP205 and automatic trans question
the th400 is quite a bit longer then a th350. and the output is bigger on the th400 so you'd need the matching 205 and adapter. or a divorced setup.. also between the th400 there are i think 2 diffrent length outputs so make sure you have the right adapter for the trans
__________________
'72 k10 lwb 454, th400, 205, d44ft, 12b rear, 4in skyjacker, 35x12.5-15 superswampers, 4.56, blazer tank. painless wiring harness '98 dodge 3500 12v 5sp 4x4. the truck that actually runs Quote:
|
|
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
