![]() |
Register or Log In To remove these advertisements. |
|
|
![]() |
|
Thread Tools | Display Modes |
![]() |
#1 |
Registered User
Join Date: Oct 2012
Location: chilliwack BC
Posts: 5
|
need some help with a T5 install
I have a 67 c10 long box with a 4 speed floor shift, with granny gear bolted to a 327, and it looks like I have a high hump 6". I've been looking at a lot of threads in the last week and have not been able to locate anything that talks about if the t5 will work in a high hump? Also, my 4 speed does not look like anything that I have found in the pictures. Mine is very short with no tail end. The shifter boot is very close to the dash. Has anyone done this t5 swap in a 67-72 chevy truck...have any pictures as to where the shifter will end up? Also, how can i find out what gear ratio I have in the rear axle without taking the back cover of? what's the most cost effective way a t5 or a 700r4 ? I'm thinking the t5 since I already have the clutch setup and won't have to chance my steering column, any help is very much appreciated
|
![]() |
![]() |
![]() |
#2 |
Wide n'Low
![]() Join Date: Jan 2007
Location: La Center, WA
Posts: 1,511
|
Re: need some help with a T5 install
__________________
Trippin Hazard.. 67 swb, Gold Member.. 68 Suburban Air Force Retired |
![]() |
![]() |
![]() |
#3 |
The Older Generation
![]() ![]() ![]() Join Date: Aug 2006
Location: Montezuma, Iowa
Posts: 25,402
|
Re: need some help with a T5 install
-
Did you see this how to.... http://67-72chevytrucks.com/vboard/s...d.php?t=438224 Pretty comprehensive. LockDoc
__________________
Leon Locksmith, Specializing In Antique Trucks, Automobiles, & Motorcycles (My Dually Pickup Project Thread) http://67-72chevytrucks.com/vboard/s...d.php?t=829820 - |
![]() |
![]() |
![]() |
#4 |
Registered User
Join Date: Oct 2012
Location: chilliwack BC
Posts: 5
|
Re: need some help with a T5 install
I looked ad both of them but still need more questions answered
|
![]() |
![]() |
![]() |
#5 |
Registered User
Join Date: Jul 2010
Location: napa ca.
Posts: 199
|
Re: need some help with a T5 install
I too have been considering this swap. I have pretty much the identical truck as you. These tech threads pretty much sum everything up. You will have no problem getting that trans under a high hump. I would locate another hump cover to cut the hole so you don't ruin the orig one. The camaro gearbox with the s 10 tail seems the way to go!!
Posted via Mobile Device
__________________
edited by staff |
![]() |
![]() |
![]() |
#6 |
Registered User
Join Date: Oct 2012
Location: chilliwack BC
Posts: 5
|
Re: need some help with a T5 install
Just need to know If the shifter will reach to the top of the hump.
|
![]() |
![]() |
![]() |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|