Door Check Pin

[wayno]

New to the group. Just picked up a 64 step side and starting to repair some bad rockers - taking the doors off and have always just drilled out these pins and replaced them with a small bolt in the past - curious as to whether there is a method to removing these successfully or where I might be able to get new ones if I have to drill them out. Thanks in advance

-Wayne

[padresag]

they drive out from the bottom up. they are roll pins
they may be rusted in.remember to support the top from the hit from below to prevent bending up
ron

[ChuckW]

Soak them good. Then like padresag said hammer out bottom up Use a nice fairly heavy bucking bar so you don't bent the bracket

[ACK]

If you're replacing them, you might like this article on how to incorporate stops like modern car doors.

[wayno]

Thanks guys... a little WD40 and some love and she came right out - thanks for the insight I feel a little stupid given how easily they came out.

-W