4L80e seal part numbers

[cjohnson6772]

I've searched unsuccessfully for these part numbers online. Any help is appreciated. 2001 4L80e looks good. I just want to replace front (pump) and rear seals before installatio
Posted via Mobile Device

[Wasted Income]

TIMKEN 4598 Torque Converter Seal
TIMKEN 9449 Extension Housing Seal

[cjohnson6772]

Originally Posted by Wasted Income

TIMKEN 4598 Torque Converter Seal
TIMKEN 9449 Extension Housing Seal

Awesome! Thank you my googlefu seemed to have failed me this time
Posted via Mobile Device

[cjohnson6772]

Couple of follow up questions. I replaced my filter tonight and torqued the pan down to 30 ftlbs. Does that sound about right since the threads are in aluminum?

My bigger question is around the yoke: I know the factory 4L80e yoke was bolted on a had an oring to seal the inside of the yoke to the shaft. I've been told that a th400 slip yoke will work. I know there is a long and a short 400 yoke. I have a short 400 yoke here. The spline fit and it a non vented yoke so it shouldn't leak. Is this the right yoke for what I'm trying to do?
Posted via Mobile Device

[Wasted Income]

Yes a TH400 slip yoke will work. You just need to make sure that it won't
1) Bottom out in the trans when the suspension is fully compressed
2) That there is still enough spline engagement when the suspension is fully extended.

There is a rule of thumb out there for spline engagement, but I can't remember it off-hand.

[cjohnson6772]

Originally Posted by Wasted Income

Yes a TH400 slip yoke will work. You just need to make sure that it won't
1) Bottom out in the trans when the suspension is fully compressed
2) That there is still enough spline engagement when the suspension is fully extended.

There is a rule of thumb out there for spline engagement, but I can't remember it off-hand.

This was my gut feeling but thank you for confirming. I guess I'll try to cent the splines at ride height.
Posted via Mobile Device