|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
04-17-2013, 11:48 AM
|
#1 |
|
Registered User
Join Date: Jan 2009
Location: Harwood MD
Posts: 9
|
67-68 lower side molding question
I assume that all the OEM moldings on these trucks would have been stainless steel? Hopefully someone can confirm one way or the other.
Anyone know what the going rate is for a good set of the lower side moldings? I would be fine with a set that has some dents and dings that I need to work out so not looking for the going rate on NOS, if NOS is really even possible on these. Thanks Mark |
|
|
|
04-17-2013, 12:12 PM
|
#2 |
|
Roadtrip!
 
Join Date: Feb 2003
Location: Grand Rapids MN
Posts: 13,713
|
Re: 67-68 lower side molding question
Not stainless. I think anodized aluminum.
Used sets can go for $100-$500 depending on condition and completeness. NOS would probably be in the $800-$1000 range.
__________________
67 gmc custom lwb dakota truck. Sold...And bought back 69 swb 4x4 project (in progress) 70 c-10 lwb texas truck 70 4x4/BB/bkts/posi/tach(retired) 70 swb (wifes) 70 jimmy camper 71 K-5 factory 2wd 71 cheyenne 4x4/tach/posi/ plow rig 71 Cheyenne20 BB, buckets, tach, tilt, 4 speed 72 jimmy CST wyoming rig 72 jimmy Colorado rig 72 lifted texas 4x4 3/4 ton burb 65 fury conv. 383/auto 65 chrysler 300 "L" 413 auto |
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
