|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
06-07-2013, 04:46 PM
|
#1 |
|
Registered User
Join Date: Sep 2012
Location: Piedmont, OK
Posts: 64
|
CPP 2/4 drop kit now nose high
The PO torched my springs so I got a deluxe 2/4 drop kit from CPP. Finished the install and the front is higher than the back by about 1 inch. Truck has a I 6 in it now... will a Small block bring it down to even? I plan on an engine swap soon. Can I combine the 2 inch drop springs with drop spindles? If I do that will the front then be too low and look funny? I like where the back is now.
__________________
"God will often give you more than you can handle so you can learn to depend on him rather than on yourself" ...Craig Groeschel |
|
|
|
06-07-2013, 05:00 PM
|
#2 |
|
Registered User
Join Date: Jul 2009
Location: San Jose Ca
Posts: 2,871
|
Re: CPP 2/4 drop kit now nose high
The small block might bring it down a hair. Drive it around for a bit and see if the springs settle before doing anything.
You can add drop spindles and be a 4/4 drop (which I would do)
__________________
David Used parts build: http://67-72chevytrucks.com/vboard/s...d.php?t=638991 My brother's Nova: http://www.67-72chevytrucks.com/vboa...d.php?t=727985 Rear suspension rework: http://www.67-72chevytrucks.com/vboa...d.php?t=750557 Instagram: myfabguy |
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
