Trailing arm bushing question

[fastlane]

After extensive searching online and on this forum, I cannot find my answer. I am installing Energy Suspension rear trailing arm bushings and all is straight forward until I get to the disk that goes on last.

It has a taper to it, the instructions are generic and their website has no further instructions regarding its orientation.

I'm assuming the taper goes in. Am I wrong? I'll take pics if necessary, but I'm sure someone knows exactly what I'm talking about.

[1moretime]

I just did mine and I put the taper in. Figured flat surface on both sides of the bushing. I don't know if it's right but I hope so.

[kamikazekyle05]

Im in the same boat, i have mine set up with the flat side out. I havent installed in the truck yet though

[fastlane]

ya, thats what I did. flat side on both sides sounds about right. I'm just surprised there isn't a definitive answer out there, for half wits like me!

[tjmeadows]

I'm going the same thing, flat side out, wish someone could give a definitive answer on this.