|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
09-16-2013, 02:00 PM
|
#1 |
|
Registered User
Join Date: Aug 2012
Location: On the banks of the Clackamas River, Eagle CreeK Oregon
Posts: 387
|
Heater core Hoses go where? <> top/bottom
Heater core Hoses go where? <> top/bottom
 I pulled the heater core on my 79’ K-30 w/AC some time back. Now that I did not take any Pick’s which hose goes where.......... Thanks’ Fellows |
|
|
|
09-16-2013, 04:03 PM
|
#2 |
|
Registered User
Join Date: Jul 2011
Location: back 40, bc
Posts: 3,854
|
Re: Heater core Hoses go where? <> top/bottom
top hose goes to rad. or water pump, bottom hose goes to intake
|
|
|
|
|
09-16-2013, 05:21 PM
|
#3 |
|
Registered User
Join Date: Jul 2009
Location: washington
Posts: 4,178
|
Re: Heater core Hoses go where? <> top/bottom
You want it to flow up so it will blow out any air bubbles
Posted via Mobile Device
__________________
377 sbc thumpr cam autogear m23 muncie 3:73 Detroit trutrac 3''spintech prostreet mufflers xpipe 1 3/4 headers build thread !http://67-72chevytrucks.com/vboard/s...d.php?t=577217 Iroc gauge threadhttp://67-72chevytrucks.com/vboard/s...d.php?t=554511 |
|
|
|
|
09-16-2013, 06:10 PM
|
#4 |
|
Dino burner
Join Date: Nov 2002
Location: Calgary, Alberta, Canada
Posts: 602
|
Re: Heater core Hoses go where? <> top/bottom
Another way to tell is that the inlet and outlet are different sizes: one is 5/8" and the other is 3/4". Match the heater core to the corresponding size nipples on engine/water pump/radiator and you're set.
|
|
|
|
|
09-17-2013, 06:36 AM
|
#5 | |
|
Registered User
Join Date: Aug 2012
Location: On the banks of the Clackamas River, Eagle CreeK Oregon
Posts: 387
|
Re: Heater core Hoses go where? <> top/bottom
Quote:
|
|
|
|
|
|
09-17-2013, 06:40 AM
|
#6 | |
|
Registered User
Join Date: Aug 2012
Location: On the banks of the Clackamas River, Eagle CreeK Oregon
Posts: 387
|
Re: Heater core Hoses go where? <> top/bottom
Quote:
If only life would remain this simple The P/O has upgraded both hose’s & fittings to match ¾” .  Not sure the gain here, if any ? |
|
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
