|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
07-09-2003, 10:00 AM
|
#1 |
|
Registered User
Join Date: Apr 2001
Location: Whitney, Texas,America
Posts: 28
|
Temp guage malfunction
What is the symptom when the resister on the back of the temp and fuel guage needs replacement? BOTH MY GUAGES PEG OUT WHEN IGNITION IS TURNED TO ON AND BEFORE STARTING.
 sORRY GUYS...THIS IS A 1972 jIMMY
__________________
1972 GMC Jimmy (topless reigns) 1996 ImpalaSS 1994 ImpalaSS too many toys!!! Last edited by oldudeSS; 07-09-2003 at 10:03 AM. |
|
|
|
07-09-2003, 12:20 PM
|
#2 |
|
Senior Member
Join Date: Jul 2001
Location: Muskegon,MI,USA
Posts: 6,026
|
I would start by checking the gas gauge sender/wiring. Ground the brown wire at the fuse panel, if the gauge goes to "0" then the problem is in your wiring or in the the sending unit.
On the temperature gauge, I would check the green wire going to the block sensor. If the gauge goes to cold with the wire disconnected, then the sensor is bad or you have the wrong sensor. If the gauge reading remains on hot, I would check for grounding of the green sensor wire. Dash units are usually good and the problems are usually elsewhere. Good luck! Jim |
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
