|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
02-14-2014, 01:13 AM
|
#1 |
|
Registered User
Join Date: Nov 2012
Location: DFW, TX
Posts: 298
|
blazer tank install without cutting bed brace
Guys
Ive got a blazer tank kit from brothers that i want to install into my 71 Fleetside longbed. The truck is stock height. I really dont want to cut my bed brace as i use the truck as a truck. So, because its stock height, im thinking that i could just run some square tubing between the tank and frame and lower the tank low enough so that i dont have to cut the bed. think it would work? thanks! |
|
|
|
02-14-2014, 02:08 AM
|
#2 |
|
Registered User
Join Date: Dec 2012
Location: Manitoba
Posts: 644
|
Re: blazer tank install without cutting bed brace
Yes u can. I did just that.
|
|
|
|
|
02-14-2014, 02:10 AM
|
#3 |
|
Registered User
Join Date: Dec 2012
Location: Manitoba
Posts: 644
|
Re: blazer tank install without cutting bed brace
Page 1 and 5 in my build thread. Link below
|
|
|
|
|
02-14-2014, 02:33 AM
|
#4 |
|
Registered User
Join Date: Nov 2012
Location: DFW, TX
Posts: 298
|
Re: blazer tank install without cutting bed brace
i should have clarified... the 19 gallon 67-72 blazer tank kits from bothers, lmc etc
most folks end up notching the bed support. im wondering if i can just lower the tank. after more research, supposedly guys have done it, but i cant see any decent pics of what was done thanks! |
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
