![]() |
![]() |
#1 |
Registered User
Join Date: May 2001
Location: Arizona
Posts: 758
|
rocker adjustment?
I have a question for you guys that know something about roller cams. I have a gm crate engine and I need to know how to adjust the rocker arms. I thought it would be the same as a normal cam, but I did what I used to do on my old engine and it didn't work right. So I need help finding out how to do it. Any one with the answer? Thanks for your guys' help.
Low68
__________________
Build Thread |
![]() |
![]() |
![]() |
#2 |
Inline 69
Join Date: Apr 2003
Location: valleysprings,california
Posts: 1,018
|
http://www.iroczone.com/projrockers01.htmlskip the first half,,,,it s for changing from regular to roller,,,,,adjustment is on bottom half,,,,
Last edited by jef5150; 07-28-2003 at 06:20 PM. |
![]() |
![]() |
![]() |
#3 |
Fabricate till you "puke"
Join Date: Jun 2002
Location: Ill
Posts: 9,403
|
I like to run 1/2 turn preload(per comp cams advice). i set mine running(the old mans ears work better than the eyes...lol!) Any way you go, you will probably have a little more noise on a full roller motor, than you would notice on the factory setup. good luck,crazyL
![]()
__________________
69 longhorn,4" chop,3/5 drop, 1/2 ton suspension/disc brakes,1 1/2" body drop,steel tilt clip, 5.3/Edelbrock rpm intake/600 carb, Hooker streetrod shorties,2 1/2" exhaust/ H pipe/50's Flows , 6 spd Richmond trans,12 bolt/ 3.40 gears.... |
![]() |
![]() |
![]() |
#4 |
Registered User
Join Date: May 2001
Location: Arizona
Posts: 758
|
Thanks for the help guys. The engine is not in the truck right now, so I can't really do it while it is running. Thanks for the advice. Has anyone done this before? I would like some first hand experience. Like I said earlier, I have adjusted the normal flat tapet cams before, but never a roller cam. Thanks
Low68
__________________
Build Thread |
![]() |
![]() |
![]() |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|