|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
06-27-2014, 10:51 PM
|
#1 |
|
Registered User
Join Date: Aug 2011
Location: Canada
Posts: 139
|
Bag length at ride height
I just bagged the front with this kit http://www.airassisted.ca/osc/full-s...5731sije9cgpl4 The bottom cup is about 3" tall and I thought it look a little too tall for the ride height I was wanting. So I put it in always before I started cutting anything, and these photos are at ride height which is around 58-60psi with dominator 2600 bags. If I'm not mistaken shouldn't the bags be longer at this height considering I'm also running 2.5" drop spindles? Could anyone with a similar setup post pics of your bags at ride height? thanks.
 
|
|
|
|
06-28-2014, 12:10 PM
|
#2 |
|
Registered User
Join Date: Apr 2001
Location: DALLAS,TX
Posts: 22,064
|
Re: Bag length at ride height
How tall are the bags @ the trucks ride height/60psi? Most 2600's would prob spec around 5-5.5" tall @ ride height. A good way to tell is measure the bag w/no air in it just sitting on the floor naturally expanded. Ride height should be close to that.
__________________
67SWB-B.B.RetroRod 64SWB-Recycle 89CCDually-Driver/Tow Truck 99CCSWB Driver All Fleetsides @rattlecankustoms in IG Building a small, high rpm engine with the perfect bore, stroke and rod ratio is very impressive. It's like a highly skilled Morrocan sword fighter with a Damascus Steel Scimitar..... Cubic inches is like Indiana Jones with a cheap pistol. |
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
