|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
10-13-2014, 12:45 AM
|
#1 |
|
MOTORHEAD!
Join Date: May 2000
Location: Devon AB, Canada
Posts: 849
|
CalTrac preload help required.
I am wondering if my preload adjustment problem is because my leaf springs are new. I set the preload so I can just barely turn the pin contacting the leaf. Then when I go for a 20 minute drive, I check the caltrac again and have about 1/8 to 3/16" between the pin and the spring. I have done this twice in the last week.
Any ideas? Just my springs breaking in?? Racing tomorrow AM. Hoping to sneak in to the 11's!
__________________
82 GMC High Sierra VortecPro 496 12 Bolt, 3.42's AFR 265 Holley 850 Performer RPM Air Gap Hooker 2455's TCI Turbo 400 Super Street Fighter TRRC 12 Bolt Eaton Posi Mark Williams Axles Cal-Tracs Hoosier 30x10.5 Radial Slick Full weight long box pickup Current best- 11.33@117mph |
|
|
|
10-13-2014, 01:38 PM
|
#2 |
|
mini truck racer
Join Date: Aug 2006
Location: Baytown , texas
Posts: 3,010
|
Re: CalTrac preload help required.
Could be . Why not preload them as a starting point like the instructions say ? Good luck
__________________
1949 5-window 1969 Camaro 1976 Chevy Luv yellow 1978 Chevy Luv Blue 1976 Chevy Luv Black 1979 Firebird Flooded in Harvey 1999 F350 Dually 2005 GMC Sierra 4.8 RCSB 2014 Explorer (wifes) My build :http://67-72chevytrucks.com/vboard/s...d.php?t=399148 Build #2: http://67-72chevytrucks.com/vboard/s...d.php?t=653583 |
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
