![]() |
Register or Log In To remove these advertisements. |
|
|
![]() |
|
Thread Tools | Display Modes |
![]() |
#1 |
Registered User
Join Date: Nov 2011
Location: Alexandria, VA
Posts: 12
|
The further I dig the more RUST opinions please
I knew there was rust when I bought it but I did not realize that PO had installed knew rocker over completely rusted out lower pillar. It is solid up where it attaches and where the door attaches but as I peeled back the rusted floor, footwell, and floor support I quickly realized that down where they tie together it is gone. Is there any way to replace that part of pillar without removing destroying a good rocker? Or other suggestions please.
|
![]() |
![]() |
![]() |
#2 |
Registered User
Join Date: Dec 2013
Location: stony creek va
Posts: 236
|
Re: The further I dig the more RUST opinions please
was in the same boat here removal of the rocker would be best if po spot welded rocker like factory drill them out to save it the rocker is not that expensive if u have to hack it up.
![]() ![]() ![]() |
![]() |
![]() |
![]() |
#3 |
Registered User
Join Date: Jun 2012
Location: happy valley or.
Posts: 106
|
Re: The further I dig the more RUST opinions please
Take a look at this thread there are a lot of pics and actually with a good welder it went quite wll
http://67-72chevytrucks.com/vboard/s...d.php?t=556115 |
![]() |
![]() |
![]() |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|