MN 2003 Duramax 2500hd parting out

[Vintage Windmills]

Not much for small stuff, everything in cab or under hood got

I may be going to New mexico and could deliver a big part or two for gas money if you are on the route from there to MN. Thats not a sure thing, but am planning a trip at some point.

Parting out what was a nice dark grey truck until a fire started in the engine bay. There are still many good parts here. I will come down some in price if you take more than one thing on the list below. The interior is destroyed. Everything under the hood above front diff except intercooler and engine core is destroyed.

The top of the engine burned fairly bad, melting all the plastic and everything that wasn't metal. The inside of the cab was totally destroyed but the rear doors and front passenger faired well with minimal or no paint damage.

Truck had about 230k and is a LB7 core.

Allison 5spd auto trans worked good, just needs a shift position switch on the outside, no fire damage besides that $750
6.5 foot Bed- is rust free. just surface rust where the paint flaked in one spot down low. Rhino or LineX in very nice shape. Inside not beat up, no gooseneck hole. Not from a work truck! A couple minor dents $750 with tail lights. $700 without. SOLD
Nice tailgate, missing upper trim $200 SOLD
Rt rear dr $225, loaded but no interior panel SOLD
Rt frt dr $200, loaded but no interior panel SOLD
Lt rear dr $150, some paint damage. loaded but no interior panel SOLD
Cab SOLD
Spare tire SOLD
Rear bumper $100 just one small 1/2" depression,
good Transfer case $800 b/o
3.73 Frt axle (driver cv boots burned $150
fuel tank $50
driveshaft $75
hitch $50
11.5" Rear axle with G80 and good brakes $800
engine core unknown condition, water got in intake $650 b/o (oil looked good, was full when I drained after)
rims 3 good ones, some corrosion $150 total b/o
good frame $500 b/0
rear springs $100 each.

I will trade for a 4.10 AAM disc axle in 4.10 ratio, dana 44 front disc brake axle (71 chevy style). Also am interested in a low mile 350 V8 (must have receipts) or 5.3/6.0 Ls series, nv4500 out of cummins, 29 spline np205, and 91 to 93 silverado red bench seat in nice shape.

I have a tractor with a forklift and can load big items onto your truck and trailer.

[lolife99]

I'm looking for a front fog lamp wiring harness.
I'm pretty sure it will be melted, but I have to ask.
We don't have pick-n-pull style junk yards in my area, so it's hard for me to find small parts.

[Vintage Windmills]

Keith, iI ccan look but if anything is good it would just be the cconnector and one ft of wire from lamp. Does that do you any good?

[lolife99]

No not really.
Thanks for the reply

[1968Mann]

I am looking for 3 of the center caps. Would you sell those by themselves?

Am also looking for hood hinges if they arent to bad.

[Vintage Windmills]

Originally Posted by 1968Mann

I am looking for 3 of the center caps. Would you sell those by themselves?

Am also looking for hood hinges if they arent to bad.

3 good caps for $65 shipped total. The hinges look ok but the springs have lost their temper and won't support the hood anymore.

[1968Mann]

Sweet I'll take them. PM me your fform of paymen and I'll get it over to you.

Would you mind getting me a quote to ship the rims as well to 72712. I wouldn't mind havhaving a matching spare as well and no reason not to just have a couple extra! I've got another 2500 with steels that I could change out.

Zack

[Vintage Windmills]

Zack, sounds good. will PM you.

2 of the rims are sold, only one remains, it has a little corrosion (chalkiness) in a spot or two of the clear coat. I'd do $133 for it and the caps shipped.

Jud

[1968Mann]

I'll stick with just the caps for now. Thank you.

Zack

[Vintage Windmills]

No problem, the rims are a pain to ship anyways

[badpeanut]

I know you said the interior is burned, but any chance there are one or two good plastic seatbelt buckle covers?
http://67-72chevytrucks.com/vboard/s...d.php?t=656060

[1968Mann]

Originally Posted by Vintage Windmills

No problem, the rims are a pain to ship anyways

That they are! I sent you some money.

Zack

[Vintage Windmills]

Originally Posted by badpeanut

I know you said the interior is burned, but any chance there are one or two good plastic seatbelt buckle covers?
http://67-72chevytrucks.com/vboard/s...d.php?t=656060

Odds arent good but i will look. Its the charcoal interior anyways

Originally Posted by 1968Mann

That they are! I sent you some money.

Zack

Zack, got it thanks!

[WigglesTheHoly]

I'm pretty sure those tail lights would fit my 05 silverado, price on passenger side or both? 67530

[Vintage Windmills]

Originally Posted by WigglesTheHoly

I'm pretty sure those tail lights would fit my 05 silverado, price on passenger side or both? 67530

They went with the box sorry

[Vintage Windmills]

Originally Posted by 1968Mann

That they are! I sent you some money.

Zack

Zack, your caps went out sat priority mail, should be there any day now.

Jud

[cmb]

Interested in rear bumper to 46239. Could you send a pic? Thanks

[Vintage Windmills]

sorry its sold. everything is now except the trans, engine.

[Vintage Windmills]

also engine didnt get water in the intake like i thought, just the trubo inlet. so the longblock is most likely ready to run. it turns over nice by hand at freezing temps, oil and coolant looked good to. Thinking i will keep it since its good.

[badpeanut]

Originally Posted by Vintage Windmills

Odds arent good but i will look. Its the charcoal interior anyways

Any luck?

[1968Mann]

Originally Posted by Vintage Windmills

Zack, your caps went out sat priority mail, should be there any day now.

Jud

They got here today. Look great! Thank you! It was just a chance I took to look on here for these since they are a pretty penny from GM!

Thanks again.

Zack

[Vintage Windmills]

Originally Posted by badpeanut

Any luck?

I looked at them and they were all bad, sorry.

Originally Posted by 1968Mann

They got here today. Look great! Thank you! It was just a chance I took to look on here for these since they are a pretty penny from GM!

Thanks again.

Zack

Zack, good to hear and glad to help.

Jud

[68bowtie]

how is the rear passenger fender flare and how much shipped to 95382?

[Vintage Windmills]

Sorry it sold. The bones are picked pretty clean on this one, all that remains is the front driveshaft, abs valve, allison (no shipping), exhaust (no shipping), springs (no ship), intercooler, and one rim with some corrsosion, thats it.