OR Parting 1972 C20

[DLTruck1973]

We are now parting this 1972 C20. Please ask about any parts not listed as we may have them in our inventory from past parted trucks.

Thank you for looking.

Power Brake Booster with brackets...$75.00
Proportioning valve with short lines...$30.00
Steering column for 4 speed...$75.00
small block 4speed clutch linkage complete from pedal to throw out fork...$65.00
Right outer door handle, real nice for a driver...$30.00
Cut from inner roof panel with "no spin" decal...$10.00

Anything else, just ask.

Plus shipping on all parts.

Thank you,
Thomas

[No8Easy2]

would you ship that inner grill? and price on door panels

thanks
Chris

[cericd]

Condition and price on the entire cigar lighter. Is it lighted? Any better pictures?

[kda2000]

I'll take the SB 4-speed clutch linkage - pedal to the Fork (with bracket and bolts to the engine block?) -- Shipping to 78737 - thanks, Ken

[Tdrcreyn4]

I'll take the proportioning valve with lines

[danny69]

What about the heater controls

[67chevy4x4c]

How much for 20 inches of the firewall floorboard

[DLTruck1973]

Originally Posted by No8Easy2

would you ship that inner grill? and price on door panels

thanks
Chris

The inner grill is busted up pretty bad on this truck but I may have another one. I will also check the condition on the door panels. I think they have some extra screw holes. Again, I may have another set. Are you looking for black or does color matter?

I will get back with you soon,
Thomas

[DLTruck1973]

Originally Posted by kda2000

I'll take the SB 4-speed clutch linkage - pedal to the Fork (with bracket and bolts to the engine block?) -- Shipping to 78737 - thanks, Ken

Hi Ken,

Let me get it pulled and get you a shipping quote.

Be back with you soon,
Thomas

[DLTruck1973]

Originally Posted by danny69

What about the heater controls

They are nice and good levers. $45.00 plus shipping.

Let me know,
Thomas

[DLTruck1973]

Originally Posted by Tdrcreyn4

I'll take the proportioning valve with lines

It is yours, thank you sir.

Thomas

[DLTruck1973]

Originally Posted by 67chevy4x4c

How much for 20 inches of the firewall floorboard

Not sure exactly what you are asking for. Are you looking for the piece of the lower firewall than is on a 45 degree angle right before the floor starts?

If you can post a photo of it, that would help. I am sure I can help you. Let me know.

Thank you,
Thomas

[67chevy4x4c]

Yes the part that is right befor the floor starts where the dimer switch bolts in the floor

[No8Easy2]

sounds good Thomas about the grill and as for the panels was hoping for black but if you have a set in good condition i can dye them
shipping is 70506

[low&slow]

What's the condition of the wheel tubs in the bed? Any pics?

[rusty knuckles 5]

how much for the inside dooor panels complete and condition thanks

[DLTruck1973]

Originally Posted by low&slow

What's the condition of the wheel tubs in the bed? Any pics?

I can check them tomorrow and let you know. I will post photos. We may have other ones available as well.

Thank you,
Thomas

[DLTruck1973]

Originally Posted by 67chevy4x4c

Yes the part that is right befor the floor starts where the dimer switch bolts in the floor

Ok, so that area 20 inches over from the kick panel to the right?

I will have to look it over well tomorrow and let you know.

Thank you,
Thomas

[DLTruck1973]

Originally Posted by cericd

Condition and price on the entire cigar lighter. Is it lighted? Any better pictures?

I have nice non-lighted cigar lighters for $15.00 each plus shipping. I can post a photo of one tomorrow.

I did have a lighted one but it is MIA at the current time. If I run across it, I will post it up.

Thank you,
Thomas

[67chevy4x4c]

Yes about 20 inches over from kick panel and down to where the floor pan starts

[Blue/72]

How are the door panels?

[DLTruck1973]

Originally Posted by 67chevy4x4c

Yes about 20 inches over from kick panel and down to where the floor pan starts

Here is a photo to make sure we are on the same page. It will be $25.00 plus shipping and it is going to take me some time to get to it. Not sure about shipping until I cut it and weigh and measure.

Let me know and thank you for the interest,
Thomas

[cericd]

Originally Posted by DLTruck1973

I have nice non-lighted cigar lighters for $15.00 each plus shipping. I can post a photo of one tomorrow.

I did have a lighted one but it is MIA at the current time. If I run across it, I will post it up.

Thank you,
Thomas

Thanks. I currently have a lighter but would be interested if you find the lighted one. Also, if you have a nice unscratched lighter bezel for a 68-72, let me know.

[DLTruck1973]

Originally Posted by kda2000

I'll take the SB 4-speed clutch linkage - pedal to the Fork (with bracket and bolts to the engine block?) -- Shipping to 78737 - thanks, Ken

Hi Ken,

Shipping on the clutch linkage parts will be $17.90 plus the $65.00 for the parts and a total of $82.90

Let me know and I will get you payment information.

Thank you,
Thomas

[DLTruck1973]

Originally Posted by No8Easy2

sounds good Thomas about the grill and as for the panels was hoping for black but if you have a set in good condition i can dye them
shipping is 70506

Here are some photos of the door panels. They are factory black panels. They are in very good condition. They would need to be detailed to look really nice. No scars on the grain with the exception of one small area on the drivers side near the arm rest.

I am asking $150.00 for the pair of these panels. I also have a very nice set of dark olive deluxe panels for $150.00 pr. I have again another set of dk olive deluxe panels not as nice for $125.00.

All plus shipping.

Let me know and I will get you as shipping quote,

Thank you for the interest,
Thomas