DIY Pressure Brake Bleeder - The 1947 - Present Chevrolet & GMC Truck Message Board Network

sodly · 04-03-2015, 10:54 PM

Has anyone made/used one of these on their original, single-circuit master cylinder? I have the clip-top style, not the spin on style. How did you make a m/c cap with an air inlet?

earl84 · 04-04-2015, 10:57 AM

I add one using 3/16 plate steel, drilled and tapped for the proper sized how barb fitting. Then used a spare deal from another master cylinder cover with the center cut out. Clamped to master with C clamp, worked well.

04-03-2015, 10:54 PM	#1
sodly Registered User Join Date: Nov 2009 Location: Nebraska Posts: 1,034	DIY Pressure Brake Bleeder Has anyone made/used one of these on their original, single-circuit master cylinder? I have the clip-top style, not the spin on style. How did you make a m/c cap with an air inlet? __________________ WANTED: * 60-66 Chevy and GMC FACTORY PHOTOGRAPHY (scans) of pickups and carryalls. *Custom Camper Club*-- Own a 65-66 Custom Camper? Join us at: http://67-72chevytrucks.com/vboard/g...hp?groupid=117

04-04-2015, 10:57 AM	#2
earl84 Registered User Join Date: Aug 2011 Location: Montrose, CO Posts: 972	Re: DIY Pressure Brake Bleeder I add one using 3/16 plate steel, drilled and tapped for the proper sized how barb fitting. Then used a spare deal from another master cylinder cover with the center cut out. Clamped to master with C clamp, worked well.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.