Dual Exhaust on a 4.3L TBI? - The 1947 - Present Chevrolet & GMC Truck Message Board Network

K8JWT · 09-02-2003, 10:06 AM

Was wondering if his is a good or bad idea as I had read that for the S-10 trucks it is advised against this move.

Engine so far is basically stock.

The trucks main use is a 3passenger car with a 8' trunk. 99% street use only.

Thank you, Jake

*1FaastC10* · 09-02-2003, 02:19 PM

3 passenger car with an 8' trunk huh? you must be hauling midgets.

Tom · 09-02-2003, 03:57 PM

Dual exasut is fine if you use small enough tubes. Dual 2" would be great.

78' Silverado · 09-02-2003, 05:29 PM

Duals are always great haha...2..or...2.25 sounds good to me as well

K8JWT · 09-02-2003, 06:20 PM

No, not midgets, just my short wife and skiiny daughter.

Don't laugh to hard as I am a School Bus Driver by trade...

77passenger pickup truck with a campertop...

87 STEPPER · 09-02-2003, 06:51 PM

1st Welcome to the addiction,

It would help if you put your location for emissions reasons.

Any way i have Edeldrock headers and there cat back system with a Dynomax high flow cat on my '92 4.3 S10.

The system is dual into singal 2.25 back into dual 2" and it is just as good or better than a dual system i've heard some 4.3's with dual's and they sound like $h!t IMO.

And if you go with a dual system you will have to use two of everything as you may know if you live in a state that has emissions insp. then you will have to install two cat's and they arn't cheap.

K8JWT · 09-02-2003, 09:20 PM

NO Exhaust inspection here in West Virginia.

I had seen many exhaust items listed for the 4.3L S-10's but almost nothing for the 4.3L R-10's.

Wonder if a set of headers for a 1987 S-10 4.3L would fit????

*1FaastC10* · 09-02-2003, 09:44 PM

oh, didnt realize we were dealing with a full size, you mentioned an S10 in your first post, and i thought that's what we were dealing with. if it were my truck, i'd upgrade to a 2.5" pipe (i believe 4.3s had 2 1/4" single exhaust) a high flow cat, and a good flowing muffler. IMO duals on a 6 cylinder of any kind sound like trash.

87 STEPPER · 09-02-2003, 10:09 PM

Quote:

Originally posted by 1FaastC10
oh, didnt realize we were dealing with a full size, you mentioned an S10 in your first post, and i thought that's what we were dealing with. if it were my truck, i'd upgrade to a 2.5" pipe (i believe 4.3s had 2 1/4" single exhaust) a high flow cat, and a good flowing muffler. IMO duals on a 6 cylinder of any kind sound like trash.

I was thinking the exact same thing too

I think a set of headers for a S10 would bolt up with out any problems theres alot of room in a f/s eng compartment just make shure if you have an automatic to order headers for that and not manual or vice/versa.

But i really think you should save some more money and just put a V8 in that full size truck and be done with it.

K8JWT · 09-02-2003, 10:17 PM

I had been toying with either having a V-8 or even a newer truck as this one has 190,000mile+ but it runs nice.

Would like to stay with a V-6 TBI as with gas hitting $1.75 per gallon around here that V-6 sipper is easier on my wallet.

Will really have to look at my "Hot Rod" ideas before I blow the money on this old goat.

Engine and tranny run great, no oil burning, good mileage, never failed to start, but the bed is in rough shape and could really use some new fenders and doors.

09-02-2003, 10:06 AM	#1
K8JWT Registered User Join Date: Aug 2003 Location: Morgantown,WV Posts: 6	Dual Exhaust on a 4.3L TBI? Was wondering if his is a good or bad idea as I had read that for the S-10 trucks it is advised against this move. Engine so far is basically stock. The trucks main use is a 3passenger car with a 8' trunk. 99% street use only. Thank you, Jake

09-02-2003, 03:57 PM	#3
Tom driving is in my blood Join Date: Dec 1999 Location: Mesa AZ Posts: 5,748	Dual exasut is fine if you use small enough tubes. Dual 2" would be great. __________________ -78 c10 short/step: 388cid, M20, 5/5 drop, lots more. Playtoy and first vehicle. -98 c1500 x-cab: 5.7L, 17" rims, 5/6 drop, flowmaster, helper bags,NBS rear disk brakes. -02 Suburban 4x4: leveled front -CBR600F4i, CBR600RR, CBR1000RR, and standup skis DISCLAIMER: I cant spell for the life of me.

09-02-2003, 05:29 PM	#4
78' Silverado \/ My Loves \/ Join Date: Mar 2003 Location: Midland,Texas Posts: 462	Duals are always great haha...2..or...2.25 sounds good to me as well __________________ 78' Silverado - Blue - (In a Coma) 04' Silverado -Red- 383 Stroker in progress for the 78'!!!

09-02-2003, 06:51 PM	#6
87 STEPPER STILL PLAYS WITH TRUX Join Date: Nov 2002 Location: Melbourne, Fla. Posts: 2,764	1st Welcome to the addiction, It would help if you put your location for emissions reasons. Any way i have Edeldrock headers and there cat back system with a Dynomax high flow cat on my '92 4.3 S10. The system is dual into singal 2.25 back into dual 2" and it is just as good or better than a dual system i've heard some 4.3's with dual's and they sound like $h!t IMO. And if you go with a dual system you will have to use two of everything as you may know if you live in a state that has emissions insp. then you will have to install two cat's and they arn't cheap. __________________ ~~Bruce~~ MY 87 STEPPER MY 99 2D/WD TAHOE

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

09-02-2003, 02:19 PM	#2
1FaastC10 Account Suspended Join Date: Oct 2002 Location: Elkhart, IN Posts: 6,399	3 passenger car with an 8' trunk huh? you must be hauling midgets.

09-02-2003, 06:20 PM	#5
K8JWT Registered User Join Date: Aug 2003 Location: Morgantown,WV Posts: 6	No, not midgets, just my short wife and skiiny daughter. Don't laugh to hard as I am a School Bus Driver by trade... 77passenger pickup truck with a campertop...

09-02-2003, 09:20 PM	#7
K8JWT Registered User Join Date: Aug 2003 Location: Morgantown,WV Posts: 6	NO Exhaust inspection here in West Virginia. I had seen many exhaust items listed for the 4.3L S-10's but almost nothing for the 4.3L R-10's. Wonder if a set of headers for a 1987 S-10 4.3L would fit????

09-02-2003, 09:44 PM	#8
1FaastC10 Account Suspended Join Date: Oct 2002 Location: Elkhart, IN Posts: 6,399	oh, didnt realize we were dealing with a full size, you mentioned an S10 in your first post, and i thought that's what we were dealing with. if it were my truck, i'd upgrade to a 2.5" pipe (i believe 4.3s had 2 1/4" single exhaust) a high flow cat, and a good flowing muffler. IMO duals on a 6 cylinder of any kind sound like trash.

09-02-2003, 10:17 PM	#10
K8JWT Registered User Join Date: Aug 2003 Location: Morgantown,WV Posts: 6	I had been toying with either having a V-8 or even a newer truck as this one has 190,000mile+ but it runs nice. Would like to stay with a V-6 TBI as with gas hitting $1.75 per gallon around here that V-6 sipper is easier on my wallet. Will really have to look at my "Hot Rod" ideas before I blow the money on this old goat. Engine and tranny run great, no oil burning, good mileage, never failed to start, but the bed is in rough shape and could really use some new fenders and doors.



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.