|
09-17-2015, 10:03 PM
|
#1 |
|
Registered User
Join Date: Jun 2013
Location: Southaven, MS
Posts: 29
|
my project
I finally dove in and pulled out the old 350 which leaked from everywhere, and had a cracked block. Didn't know that till I pulled it out. So far I have redone the suspension. Put CCP 2.5 inch drop spindles, upper, and lower control arms. New rotors and calipers. New inner and out tie rods. New pitman arm, and idler arm. Just pulled all the dash components so I can start putting in my painless performance wiring harness. Then I'll be able to finally put in my Chevrolet Performance 350/ 330 hp crate motor.
__________________
|
|
|
|
09-17-2015, 10:08 PM
|
#2 |
|
Registered User
Join Date: Jun 2013
Location: Southaven, MS
Posts: 29
|
Re: my project
my engine
__________________
|
|
|
|
|
11-05-2021, 08:10 AM
|
#3 |
|
Registered User
Join Date: Mar 2011
Location: Lancaster,Oh.
Posts: 138
|
Re: my project
What is that seat out of?
|
|
|
|
|
11-05-2021, 08:13 AM
|
#4 |
|
Registered User
Join Date: Mar 2011
Location: Lancaster,Oh.
Posts: 138
|
Re: my project
Nice project.
|
|
|
|
 |
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
